Viewing all customer Discussions for:

Other

The lever on this sliding door latch does not stay on - see attached/detached pictures. I am looking for options to either replace the lever or the entire lock. If replacing the lock, ideally one with a low profile exterior handle would be preferred as there is not a lot of width between the door an ... (cont.)

How to install

Need weather stripping.

Thanks for any part numbers you can provide: CODE: STA, SPEC: C-R65, Series: Ultra 2000 LITE CASE, MST: 2650, NFRC 100/200 ASTM F 588, 101.I.S 2-97.

The end of one of the clips that secures the sliding glass in the Emco storm door is broken. Can you provide the part number and pricing for a replacement clip.

Need replacement

I have one bad sash balance and would like to replace both. Window ID is LIN 1194 U32-HVS as shown in picture. I've uploaded a picture of the bad sash balance (the spring from it is missing) and a picture of what I believe the sash balance should look like. The length of the metal channel alone is 2 ... (cont.)

Replacement hardware

need wingless patio door limiter(1/2') longer bolt hope you have it in stock or can advise me where i can get it....thank you wolchuks

Hook at top of windows. Pulley at the top of mechanism and second attached to spring. Bottom of spring attached towards the bottom. The channel is 1". 34B stamped on it. It measures 34"long 1/2 wide and 1/2 deep. The spring is 20".

I am in need of a right 10 inch hinge for a pella casement window your website said you are out do you know when you will have?Also need some of the pivot screws the hinge pivots on as in photo.And the plastic hinge stop that says wash on them.I Have the shoe 39-371 and pivot plates 39-363 in my car ... (cont.)

I am looking to purchase a door handle for the SGD-R30 sliding glass door. Thank you!

17/32 x 1"1/4 x 2". I think i was holding it together properly but not my wheelhouse. It would be connected to the 25" series 600 spiral tilt window balance, S600-25. Thanks for helping.

28D stamped on channel. Actual length of metal channel is 29". 9/16 wide

Looks came for the height of war of window

I'm looking for the white bracket in the photo. It has a threaded core so it rides back and forth along the screw crank which tilts the top sash of the garden window open and closed. The plastic has deteriorated and is crumbling.

I have a bedroom set purchased sometime around 1995. The plastic stop has broken on most of the drawers. I haven't been able to find exact replacements. They have sharp angles instead of the curved pieces that hold onto the drawer slide. What are these called and do you have replacements or other ... (cont.)

Trying to determine the manufacturer to the G-x7166 Window Seals/Weather Stripping shown in picture. Thank you.

From a mid-1990's Eagle (i.e., Anderson) sliding door. Your 82-044 looks similar, but not exact. Will it fit? I have included shots of screws since your part specifies #10-24 screws. Will my screws fit your part?

I'm trying to find window pivot shoe locks, I previously order the S140-10 hoping they would work, but the they were too small. I've uploaded photos of one of my old broken pivots. I measured the width of my old pivot lock and it was 7/8 inches. The spring had "406" stamped on it, not sure if that m ... (cont.)