Viewing all customer Discussions for:

Other

Thr bottom of the window tilt out is broken. This fits thr bottim of the windownitself

My door will not lock. Looking for a replacement part. In the picture that is included it looks like it measures 6 in. May need the lock lever as well

The roller on the bottom of the door is labeled "Acme 4011" The roller on the top of the door if labeled "4013-2"

Please help me find something that will work with channel balance is S385-25. "385 channel balance", This is the original top. Thank you

Hello I am trying to replace the handle for my sliding door. It has a double mortise lock. The inside handle broke off. Please advise. Thanks

My house was built in 2003. I believe the windows were built in Nebraska and shipped to the building site in Colorado. The windows appear to be very nice heavy windows, wood with metal cladding. The piece I am looking for is attached to both sides of the window and it goes into a spring to keep the ... (cont.)

I assisted a relative with finding a mounting bracket for her sliding door SGD-C30-96x96. Her order # was 1523582. The item # was 82-108 and upon receiving it the holes fit into the door but the overall part is smaller that the original. See the picture with the 82-108 installed with me holding th ... (cont.)

Hi, Would you please help me identify the right replacement balance for my Milgard single hung window? Please see the pictures of the old balance, measured 27" channel portion. The sash measures 29" x 33.5", and the slot is about 1 1/4". Install time was 2002. I'm not sure about the weight of th ... (cont.)

I cannot find manufacturer information on the window. What is circled is what I need a replacement for. I do not think you guys are the one to know, but I thought of asking anyway. I am clueless about who to contact. Thank you for your time

Hello Im looking for a balance for my window or maybe just the shoe. Do you offer either of the parts?

How do I remove and replace a pivot shoe?

Looking for the following; left and right operator 3/8 shoulder bolts with 5/16-24 thread. 3/8 shoulder bolt bushings. It has a straight link arm.

this is a custom pella door i can not identify this seal i had sent you an email to help at swisco.com many thanks Mike

The clips that hold the window straight when you pull it up are missing and then the plastic part that goes around the tube guide is also broken

I am looking to see if you have the release lever for these windows. What item number it would be?See photos Thanks Sam

Good Afternoon, Please assist with finding a replacement proper door handle with the right hardware tools. Thanks, Jennifer

It is a window balance for a heavy storm window. What info doe you need

The extension arms show the marking Truth 40011 and 40012. The handle and I assume a "worm" gear is missing.

1954 original on crank out verticle casement type window. Crank handle does not engage internal gearing. Have not yet been able to disassemble from window frame but aim to extract assembly and replace.

need 3 sets of Tilt Latch Pairs for Simonton windowsThank youRaymond