Viewing all customer Discussions for:

Other

I have 30-60 Mayfair windows series 21-20. The numbers I see on the window: CMF-1 ASTM E774 CLB ALI 00-BThe pivot bar on my windows have rusted away from the pivot shoe (at least that's what I think they are called). I need to replace both. I would appreciate any help you can give me identifying the ... (cont.)

Need door handle replaced.

I'd like to purchase 4 (four) Top sash Channel Balance Guides. Please see attached photos. Dimensions are 5/8" wide x 1 1/2" long. These are from Millguard windows. I recently purchased two replacement channel Balances - see order # - Your SWISCO.com order #1436220 has shipped. After changing ou ... (cont.)

The marking is 3640. I reviewed all the measurements and they seem to align with the Series 380. The dimension that is off is on Winged Channel Balance Shoe. The 1" depth measurement is between 13/16 and 7/8" on my balance shoe piece. Will the 380 series work for me or is there another series? ... (cont.)

I need help with replacement locks. The pictures are from an early 90s installation. The inside is marked Truth & 40226 I need 2 left and two right. I would also like to know if you make a cover for the operator in the picture. Thanks!

I am looking for 4 hinges for my Larson door see attached picture I can't find any with the three hooks.

Part says 27301 1/2" wide 28" long i can't find any other numbers Thank you

I'm looking for them replacement parts,can you help identify these parts

I cant locate a lot of info on the manufacturer. We have asked around and are waiting to hear, but this part seems pretty simple to replace, if we can find it.

Hello, I'm looking to replace approximately 10 encasement operators from the attached photos (5 RT, 5LT)...I recently received an order fro swisco but they unit(s) do not fit.Thanks!

Here is the data for our patio door. One of the rollers broke. I would like to purchase two pieces of each side of the door in case this happens again. Please contact me so I may place an order.

need Bottom Vinyl channel to hold 2 glass Panes and to mount tilt in bar on . Bar is 3" and mounts with 2 screws (need one) and (need one Spring riser assy) on one side

Coil measured 1/2" wide. Window is around 28" tall if that helps at all

I will need two of these I cannot identify the brand or the part number thank you

need replacement vinyl window tilt locks with or without screws measuring 2 1/4" long by 5/8"

Need new latch

I would like to replace with new ones. See attached pictures. The house was built in 1990 so I assume the original parts are from around that time. Also I would like to replace the cover and crank handle with new white ones. Which parts do I need to buy? Can you send me the parts list for the full s ... (cont.)

Looking for 4 clips to attach screen to jalousie front entry door

Hopefully, you can help me. Here's the specs: Milgard Trinsic, 2630 SD2, 1" setback, Ext White/Int White U-Factor: 28, SHGC: .22, VT: .52 1/8" SunCoatMAX (Low-E) Tempered over 1/8" Clear Tempered Argon Gas Filled Tariff Size: RO 50"x80" Net Frame 59 1/2" x 79 1/2" Model: Sliding Door Two Pan ... (cont.)

Hello, I'd like to order a replacement window balance "Photos attached" What is the correct part # Thank you Gary