Viewing all customer Discussions for:

Other

There are no identifying numbers, letters, or logo markings on this latch. It's the only piece that locks the window, the latch locking part goes between the small space when the window is closed. The front of the latch (the small white piece) broke off leaving it jagged. I can still lock the window ... (cont.)

Hi,the windows are made by Pennco INC and i need the pivot lock shoe and the house where buld on 2002.

Looks similar to the 81-278 1-1/2" metal wheel in what appears to be a brass housing. They are for a kiosk door at a gas station, nothing fancy. I only need one but I figure I should do all four while I am there.

Hi, trying to order parts for these windows..just moved in. Found these stickers on the bottom of the window. Can you assist?

Handle and lock is one piece. Screws are 6 5/8"

The stamp number is 27F Its for a friend and I don't know what the plastic ends look like. He needs 3 units. The Channel measures 9/16th X 1/2 can you help me with this and any part numbers that may be relevant to this particular unit?

Hi, Im looking for a replacement channel balance

Hi am looking for the handle spindle like the one in the picture.

need to replace both sides. 30 inch is correct but top and bottom tabs - unsure - photos will hopefully help.

Which lock can replace with a key?

Lock reads PADO patendeada LATAD

I need the one for the left side

i have a 2018 Tuscany Milgard 2 sliding patio door. looking for a keeper for 2 point mortise lock. picture of the keeper attached. if you have the 'keeper' please provide part number, link to pic and how to order. thanks

Hi. I'm looking for a replacement latch for Patriot (Ply Gem) windows installed in 2008. The top surface rectangle of the latch measures 2 1/2" x 1/2". The underside is 9/16" wide and the thickness is 3/8". Thank you.

Snap in plastic panel retainer.

Hi. Need part number for no-tilt window channel balance. It has an imprinted label that says 3350 BE B.S.I. Its depth is 5/8" and length is 34". I need two of them for both sides of the window. Please see pictures attached for further information. Can you kindly help?Ali

2 wheel with metal ball bearings. Attached is pictures with a tape measure. the back with the adjustment screw and the attachment screw is smooth, the top that rests against the bottom of the door has 2 small protrusions. I have attached a photo of the sticker on the frame of the slider. I hope this ... (cont.)

The part that holds the glass in place is cracked on three windows, I think they're called window glazer beads. Do you have something that we can use to replace the cracked portions as seen in the photos?

The crank worm gear is disengaged from turn gears. I assume the crank worm gear cannot be fixed? So, entire operator must be replaced? Left and right.

The locking mechanism is the 1973 Canadian patent 919213 but I'm looking for the handle preferably with the aluminum finish.