Viewing all customer Discussions for:

Other

Hello I need help identifying my channel. It has 29-4 written on metal frame. Metal frame length is 30" exactly. I think its your S380 or S385.I didn't no how to measure shoe.Please call my cell if need to. Thank you Saul

Trying to find the correct balance/guide combination to match what was removed (2305). The bottom guide seems to be smaller than any I have seen, in particular the 7/8 measurement. Most bottom guides are over 1 inch for that dimension. The top guide I'm thinking 60-508. I have a couple other numbers ... (cont.)

Where can I find parts in Phoenix Az or can I order parts?

I need eight of these. 3' x 4' sliding mirror closet door roller would be would prefer metal with actual bearing rather than plastic with a simple metal rod in the center. I don't know if you make them out of metal with real bearings I was sent inch and a half wheels in diameter which are not anythi ... (cont.)

I have a broken sash guide for a up/down sliding window from Atrium. Attached is a picture of a good and a broken guide. Can someone help me with a part number for this.

Notice upper left corner where the spring broke out of the vinyl Looking for entire part. Balancer and vinyl. Thanks

I have had no luck finding this type of seal anywhere in the Clearwater Florida area would appreciate some help.

The bolt lock on my sliding glass door got damaged and I've had trouble finding replacement. The door is a Legance 3 Patio Door series, type DDSG, code TRI-K-36. any help in locating replacement parts would be helpful. The rod also needs to be replaced. Thanks, Julie

I need this for my Therma Gard windows from Season All. All I see on Swisco.com is the single hole version.

What SWISCO part number do OI need to order based on the photos and number stamped on the channels? I have replaced the channels in a prior home just not sure what part number i need now.

Hello, I have 2 PGT Windows. 34.25" wide x 31.5" tall each. I want to replace the balance springs - total 4 balances springs. Markings on the side are: 29 4 LU CMC 7. Can you tell me what product I need to purchase? Thank you, Marc

I need two rights and one left

I cant find this stop anywhere, not sure of the door brand. The homeowner stated is is an Anderson door.

Hi...Looking for sash cams..There were no marking, names or numbers I could find. Have attached photos of existing cam.Thank you for your helpJohn

The plastic cord that attached the sweep lock to the tilt pin is broken.

There were no markings I could find

Looking to replace this cracked handle. The screws are 4 inches apart. I'd rather a hardier handle than what's shown in the photo, which is largely thin plastic. The sliding door doesn't roll well, so a sturdy handle is necessary.

Need 2Thanks Clancy

I need 3 balances. The damaged one has "swisco" and "34B" stamped on it. The window is 72 inches high. The balance appears to me to be a series 795 (my guess), but with a cable and hook on the end instead of what is shown on the series 795 picture on your web site. The balance is mounted with a ... (cont.)

I have multiple locks that no longer lock or unlock on my Thermalguard windows.