Viewing all customer Discussions for:

Other

I'm afraid My order may have the wrong end. 29" Series 380 Channel Balance. I am sending some photos of my track to confirm? (Order was cancelled).

Looking for the weather strip on the right of the picture of two side by side. I was sent by my boat manufacturer the one on the left with has a base of 1/4" which is too wide. I am looking for a pile with glide that has a height of about 7/16" and a width of I would estimate 5/32". I would be go ... (cont.)

Need about 8 of attached my attempts to obtain replacement s via your web site little success

Please help identify the parts I would need to replace for these rusted window cranks.

I need latches for 3 windows. The attached photos show the only markings on the windows.

looking for crestline glazing bead that is close to this profile. window is from the early 80's Daylite size is 18 1/2 x 66 1/4. Unit thickness is 7/8

Need all the hardware that holds the windows up. .550 diameter with the blue tip

The corner on the left is the original. The corner on the right is your 95-270 On mine, the main male part is 1/8" thick. Your male part is 3/16" thick.Both secondary male parts are the same at 1/16".My corners are labeled 783 or 782.Your corner is labeled 784.Do you have a corner that is 1/8" mai ... (cont.)

Looking for Pennsylvania House furniture drawer stops for above named furniture. Photo attached. Please advise what part will work as a replacement.

Need to replace this part on 2 windows.

I need to find this sliding roller glass door part for a ANSI/AAMA 101/85 SGD-R15 2 1/2" L 3/4 " W roller 1 1/4 ""

I have a general garage door window cover made of plastic 43 1/4 by 17 1/4 that's has to be replaced

Replacement hardware 13 windows

I need to purchase and replace the channels on my Pennco window. I have attached pictures of all parts and channel ID info.I believe your 770-34C channel will work - Please confirm if this is what I will need to purchase.34" plain channel, (left channel ID is 33HD / BSI BV) (right channel Id is 33C) ... (cont.)

If you cannot read the number code in photo "Door lock 2", it says 2300-1061-2. The lock is broken and we're trying to find a complete replacement for the lock most importantly but also the handles. No other markings, names or numbers to be found anywhere on the door.

Please advise of you offer this product

Need to get one of these

Here are five photos of the handel I need in order to open my Caradco crank out window. Do you have in stock? Thanks, Don

The model number is quite clear: 213-K-016 but I can't tell from the logo who the manufacturer is. I may need to order new rollers.

Milgard window operator replacement. HA0429OP Casement LH Maxim Dual Arm Operator E-Gard. HA0430OP Casement RH Maxim Dual Arm Operator E-Gard I am looking for a Milgard window crank/arm operator for a Milgard 1998 casement window.