Viewing all customer Discussions for:

Other

Not attached to shape, just looking for a suitable replacement

These tilt window sash locks are 2 7/8" long 3/4" wide and 1/4" deep. The only markings are IR and 092.

Need help identifying your replacement part number. Thanks.

Hello, I am looking for the replacement part for my window balance, I would like to buy the whole set but I don't know how to choose the correct one and I will appreciate if you can help me. Thank you. Ronald.

I Have an ACME 17-4405 block like the picture above which Needs a spring loaded pin and also a broken glide in the bottom of the door track #17-4466. I hope you can help or point me in the right direction. Thanks Jerry

I have the attached and can't find locally and not sure if I see it specifically in all of your photos. See two ends and the weight stamp (I think). The exact length of the metal only is 27 5/8 " long and 1/2" wide Do you have?

Markings on Chanel balance 1700 W non-tilt window 1/2 wide 18 inches long. Would S350 option 1710 work?

Hello my name is Jeff back sliding door is rolling very rough I took out the doors inspect tracks and clean out and the tracks were good, but the wheels roiling very rough and wear down so if you can help me locate where i can buy these wheels. Thank you.

82772 are the numbers on the hindge pin of the double hung tilt in windows I have. I have photos of the pin also if they may help I appreciate any help you can give me on this matter

My window is about 36" X 15" awning window. The gear slips about 1/2 way out and binds up coming back in. The house was built in 1996. It's a single arm operation. The number on the arm is 1521101. The only number I could find. Need the crank assembly. Thank you. Joel

Pella sash lock nickel finish

Marking on old part is 22 3 HR CALDWELL

i need one set and two springs

Need the plastic round knob that goes on the end of the operator arm (the part that fits into the window frame). Looking from the outside of the house, this arm is on the left. Thankyou,

This is my second trial. I tried to send a photo, but that failed (My photos are jpg)and my message seems to be lost. The string broke in a channel balancer. The window weighs 15 pounds. The balancer length is 16", width 1/2", top looks like 19-002, bottom is 7/8"deep, winged and looks like 15-005. ... (cont.)

I am unable to determine the name of the company that made my windows. I am missing a few of the weep hole covers. I would like to just install new flaps if possible. If need be, I would replace the entire unit. Please help identify the part.

hello, I have an Andersen balance with 9P27374 stamped on it. Can you tell me which balance I should order? Thank you

These are about 6 years old the windows are from like a wallside or hansons.

This spring broke and we have to keep the window locked in order to stop it from falling down. I can not find any marking on it to determine the weight of the spring.

The cord broke in these and I need to replace them. I'm not sure how to measure the foot (which angle is measured)The slide is 33" long from end to end including the tip and shoe. It has the following printed on it "31 3 HP Caldwell". Thank you for your help.