Viewing all customer Discussions for:

Other

Hi. Purchased these, but they didn't hold the weight of our kitchen drawer for very long. Do you have other options that are of the same size, but sturdier or where the part is one piece instead of one part that fits into another part? Part #32-012 comes in 2 parts. Thank you for any sugg ... (cont.)

Are you able to ship this to Hawaii?

Need replacement bumper/guide. No marking on part. No idea on manufacturer.

mine says Acme on the back on the back of the front door it says 1 3/8"front 3/4"rear on the rear door those numbers are reversed I just don't know which ones to order

Couldn't find any name or numbers. Not sure where else I could look. Thank you for your help! Laurie

I have a set of window balancers that need to be replaced. The pieces are 16" long and marked with 14 3 AO Caldwell Your assistance is appreciated.

I need some screen retainer clips to keep the window screens in place. See photos of clip and identifying numbers for window

Can you help me find this?

Hello, I bought a house that had windows but no info on them. From analyzing the windows, I was able to determine they are Acan from 2010. I am looking for the silver piece detailed in photo 1. As of now, I am not able to raise the window because it won't stay in place.

The lever on the exterior handle of my Sugarcreek storm door (Model 399; installed 10/2006) snapped off so I need a replacement in bright brass. All other hardware parts are in good shape (lock, interior handle assembly, latch assembly.) Please recommend a replacement. It would be especially ... (cont.)

Dear Swisco, Can I order 2 sliding door roller as on the picture. And is it possible that you send it to the Netherlands?Europe Kind regards, Fred

I have included a number of photos. It is a non-tilting window. Old channel has marking of 2790-BSI-OJ-30. It is 29 inches in total length.

Hello,I'm searching for a replacement for this screen corner. Thank you.

Please tell me the part number for these

1.screen corners2. Sash pivot bars3. Tilt sash locks r&lDon

I'm in a pinch and need to order some of these. Please advise.

Thanks for your prompt response to my issue.My pin is 5/16 inches diameter and 5 and 1/4 inches long. The hole for the cotter pin is 2 inches from one end. Nothing seems to look like my set up, can you help me? Thank The steel pin I have is 5/16 in diameter, I see no pins with any more than 1/4" in ... (cont.)

NW1720-3 the latching lever is split in half..I would like to order the whole set if you have..Thank you -Bobby

I could find this part At Home Depot but the depth dimension is too shallow. Theirs is 1 3/8" deep and the one I need is 1 3/4 deep. Otherwise they would be a match.

Hi. The part of our slider that broke is the latch that locks/unlocks the door. I have looked to buy a new handle, but no one seems to sell the lock plate with a new handle so I need to find either the whole set or is it possible to only buy the piece that broke off? I appreciate any assistance. Tha ... (cont.)