Viewing all customer Discussions for:

Other

sliding lock for the door

Pennco single hung vinyl window , part# J1MAOW3660 *A ,2070sh 3050 3/4 mm EL low E W, Tilt carrier is broke ,need replacement part!

Need a replacement for a rusted 1 1/4 concave metal for a outside screen door

The coil spring balance has no indentifiable markings, but is 1/2 inch wide, and two spring balances are required, one on each side for the window to operate properly.

Hi, Here are the dimensions for the pins that we need. They are 4' long, the top part of the shaft has a 3/16" diameter, the lower part of the shaft has a 3/8" diameter. The metal dome on bottom has a 7/8" diameter. The top plastic part has a 3/4" diameter. Photos attached.

I'm looking for these for quite a few double hung windows. I cannot remember the make of the windows. Any help would be appreciated.

It goes on s400 series

29c EF5 omc 45

Can you identify the part in the attached picture?

Anybody know where I can buy this?

Wow...wish all businesses I deal with were as pleasant and knowledgeable as Jasmine!

I need a Pella 03L60011 Standard Active Hinged For Handle, LH, Satin Nickel plus an )3L70011 standard inactive hinged door handle, LH, Sain Nickel, plus an )BLT2001 Random Keylock, stainless steel (Pre July 2016). If you have anything like these items that would work for my Pella double doors, I wou ... (cont.)

The one piece has the numbers 1446. The other one has the numbers 144 d-1. Something like that

I need to replace two split arm operator

I am looking for the roller for our windows, I will need at least 20 pcs. if I can find it. thank you very much. Slide-Co 131244 Sliding Door Tandem Roller Assembly with 1-1/2-Inch Steel Ball Bearing by Slide-Co

Can't find 1 1/2" top to bottom

The lock part that attaches the internal thumb dial with the bolt has sheared off and I need a new one. Everything else with the door is fine. The door part says it is a metro style.

Hi my name is Yvon I would like Seven set for windows.

Hardware measures 3" x 2 5/8" x 3/4" thick. 4 screw holes 2 3/8" apart. Looking left and right hand latches. Thanks.

It is 30" measuring just metal. Has a number printed on it 29-5 KX CMC 7. Do you have a way to interchange this information. I'm not sure what weight I need so I can purchase 2 pair.