Viewing all customer Discussions for:

Other

I have some mirror closet doors that i would like to just fix and need to know what wheel parts i need in order to repair. Thank you for your time.

Just bought the house and need to replace these on my sunroom sliding doors. Cannot find a manufacturer on them.

Hello, I have recently purchased a home with PGT double hung windows and the weather stripping on the lower pane has mostly disintegrated. I am hopeful you will be able to help find a replacement stripping. Please find photos attached.Thank you,Al

I'm looking for a replacement part . My curved shower door slides open and close on a track but the bottom part always becomes unclipped . I can put it back on track but it happens all the time . It rolls fine on the track except for the fact that it comes out when you slide the door . I can't fin ... (cont.)

I'm guessing these doors and hardware were installed in the 1980's

I tried your Item #82-016, Surface Mount Handle, Set 3.5". It was Order #1324066, which I've submitted for return. I need the 3.5" set but it wasn't going to work for me because it was too unstable and had an "edge" lock, vs. a center lock. The photo show: 1) the broken handle, 2) the handle on t ... (cont.)

Both window balances are broken They are stamped "IMP 29 DS 38 BS1 BT " The IMP DS and BT arestamped vertically in smaller type. The metal portion is 30" long. Window is about 30# or more and swings in from the bottom when lifted without the balances.What model do I order?James

I can't seem to find the type of window balance

No visible numbers, windows from the early 89s id say. Theres a US Patent # engraved which is 5620213

Says 29 3 ES Campbell on them

my customer is wanting (1) per the attached pic.Gene -Thank You

need two balances for this window

Hello, I am in need of 3 sets (6) Top Sash Guides for a PGT Single Hung window measuring 35x48. These 3 windows do not currently have the top sash guide so I'm not even sure how to identify what I need - are you able to assist or need more details? Your attention is greatly appreciated!! ... (cont.)

Looking for the replacement window

Hi, I need to replace a channel balance - the only marking I can see reads "25 5 IS CALDWELL". After reviewing the site, I'm pretty sure that I need a 26" Series 385 channel Balance. I'd appreciate any input.

i need to relace a couple of these can you help me thank you

I have 23" channel balances that have the markings 23 5BSI R with a half moon after it. I would like to know what the right unit would be for my application.

I am looking for a replacement part for a roller on a Stanley sliding mirrored closet door. Any suggestions?

The tilt latch part is 3in X 7/8 in and I desperately need four of them. After reviewing your inventory I didn't see any parts that fit. Screws are two inches apart. I hope you can help.

Plastic bracket at back of drawer hardware to hold slider in place. Existing piece has a large G with the numbers 6020 6 and either RH or LH after the number. We have located similar items but they are not large enough for the drawer hardware. Need opening approximately 1 inch by 3/8 inches. Th ... (cont.)