Viewing all customer Discussions for:

Other

Our Transom window opens when cranked but when trying to close the window it stops closing even when cranking closed. It appears that the threaded ring piece on the crank arm holder is not seated properly in the hole. We have a second transom window and the threaded ring piece is seated within the ... (cont.)

Hello,I'am trying to identify and replace the hardware pictured. There are no logos or markings to identify the make or model. I see from previous postings that the markings on the glass has no connection to the door hardware. Any efforts to identify the model and where to purchase would be appreci ... (cont.)

1.5 inches front to back, 4 inches high n with the metal stop on front 4.5 inches in height

These assemblies are 26" long not including the plastic ends. The only identification I can find on the metal channel says "25 4 CALDWELL GM".

There are no marking on this at all. It comes from a slider probably from the 1990s. It is held in place with the ears on each side which set in a slot on the door. Would it be possible to just replace the wheels if the whole thing is unavailable?

Hello, can you identify the top and bottom part. This is a 24 inch long, 1/2 inch wide B.S.I. # 2320DG. What is the proper replacement part from Swisco? Thanks.

Can you tell me what part I need to buy? The window coil has come off the part and no longer slides. The Part number is 5,353,543 Please see photos

need to replace this part, roller damaged

Hello, My window won't quite latch. Is there a latch like this that is adjustable so that it will engage properly. I am off by a little more than 1/16" Thanks, -Andre

Non-tilt window only markings on the channel balance are 2320 width 1/2" approx 25" long Home was built in 1981

34" LONG WITH THE ENDS AS PICTUREDMAGGIE

Anderson bay window. Crank out center sections latch handle

Hi, I had my kitchen installed about 30 years ago and many of the hinges broke. There is a black plastic piece that breaks and falls out and then the cabinets won't close. I tried a few places and no one can seem to find replacements for me. I hope you can!

We have a weather shield window that was installed 2002-2003 that has clouded up as can be seen I also sent a picture of a clear one. There are no markings that can be seen. My builder and a window company locally said they can't get parts. Can you help

I need a pair of hinges to match this one. It didn't have a part # that I could find. Thanks

We need to replace 4 14" Getty operator arms in a Parrish Hall from 1961

it is marked 11600-17 and also E53 9#27 1-87 on the other side. I need (2) each of left and right hand assemblies.

one balance is marked 2120F, the other 2120 Q; one discernible differences 1) the color of the top shoe (immaterial). Not sure if I'm looking at S351 or S390 but I'm pretty sure its a 1" shoe depth cause there's seemingly nothing 1 1/8" about it. 22" length balances for sure. Thanks! ... (cont.)

Looks to be Nylon, mine is broken. Large letter L on upper left hand attachment plate, apparently to identify left side. Smaller letter D in extreme upper left corner. On the right side of the plate, large letter G with an asterisk above it on its left. 6600 written below the G. Large letter G pri ... (cont.)

metal measures 21 inches long. I Need a total of 12