Viewing all customer Discussions for:

Other

I am looking for the part below. Is this available? Patent US6155010

I'm looking to replace the tilt latch on this 2500 Atrium window but cannot find a match. can you help. Thank you so much Laura

I?m needing to replace the vinyl trim around the window which is a flat type. Do you know or carry this type of product and how are they installed? Thanks

I have a 6-foot patio door with a sliding screen. I have looked all over but do not see any brand name on the door. The attached pictures show that the weather stripping on the screen door is fuzzy and secured in a groove with a plastic strip. The door is 10 years old and gets lots of sun so the pla ... (cont.)

Hi, this is Jim. We have to replace some anderson string balances. The Stamped number on the part is E11 9p27 374. I couldn't find that exact matching number in your selection. Which one do we need. Please get back to me about this as soon as possible.

Can you assist me with purchasing the correct channel balance? I need 4. Looking at your site, I?m not quite sure which one would be correct. Thank you!

Need to replace the crank mechanism as shown. No brand markings on it.

I need two window Chanel balances 2640

I need 4 of

I need some replacement window cranks. I just ordered a 11/32 crank handle because it might work. I actually made a clay mold of the spline and could send it to you if it doesn't. When i get one that fits, ill probably order about a dozen to replace all the ones that are missing. ... (cont.)

My channel balance is 30" long and 9/16" wide. It goes in an aluminum window manufactured by Larson industries, model SH 7500. The stamp on the balance is 2920. I need a replacement series. Thank You

Hello, Can you help me to order 2 replacement balance springs for one single hung window. I cannot see any other manufacturer markings accept those on IMG-6504.JPG Rich B

i could not find window numbers. i only have pictures. i measure white tube 35 inch length diameter of tube 9/16 ( you can see picture) help to identify balance part

I need 2 window spiral balancers for a 2832 Aspen series window. Can you supply them or tell me where to get them Thanks, Bill

Do you carry .187 backing x .200 pile height - not zipper back

this is stamped 29DS 48L. I need 6 of these. Thank you

Also the lock latch does not lock its to hard to pull down and other window the crank broke off. these are front windows that open outward.

I am trying to find replacement balances for my Peachtree window. The code on the balance is D3066 made by BSI. Channel length is 29.25". Any help will be greatly appreciated. Thanks. Gene

Hello! I need 2 spring balances for a 35"x23" aluminum single glazed sash, (sorry didn't weigh it) The aluminum C-channel is 22" long (w/o ends). and is 9/16" x 5/8" in cross section I could see an ID stamp: 21 A near one end Thanks for your help. -Kurt

I need 7 sets of the above latches, left and right. The latch slides in and locks down.