Viewing all customer Discussions for:

Other

I believe the balance is a S210-10 (it says 10 on the side of it) I can't find the pivot pin on your website I believe the bracket is a 16-030 I need to know all 3 part numbers since I need to order multiples of each part Are there any special tools needed to help with the install? Thanks Steven ... (cont.)

Greetings, my name is Jim. Can I buy a part from you to repair my windows locking action? It won't move the bar that engages the catches on the swing out window. I have attached pictures. I believe these windows were called the Windsor Dimension series. My house was built around 2004.It's the left w ... (cont.)

I have these door hinges gone. Needs to replace. Mahesh

Need locking handle

the wound support has a plastic sheath, very brittle and gray. the bottom of the balancer has a hinged flat metal plate that tacks on the underside of the window. I have no idea what type, brand, or vintage this window is. There is a hole at the top of the grey round part where a nail is holding it ... (cont.)

I have an older storm door with no manufacturer labels or identification and several panel clips are broken off. Am looking for replacement clips.

Might be a 40 year old door

Good morning, Thank you in advance for any help you may be able to provide. I'm in need of 3 hinges that are the same as the pictures attached but in oil rubbed bronze or black. These hinges are unique as they have a slight bend as you can see in the photos on the non square side. This bend is need ... (cont.)

This latch is 2 inches long. I don't know what brand it is. The cross section is shown in the photo.

I tried the Franklin undermount sliders and I just cannot get them to work. So I deceided to give you a try I watched the video on how to use your product.

Metal channel balance bracket is 29 inches long X 1/2"-9/16th wide/width. One photo is showing the markings on the Channel balance unit

Can be identified.

Hello, my balance is exact to the discussion screenshot I provided. The only difference is the length and stamped number. Length: 52" Stamped #: 5240 For quantity: I have 2 double hung windows and need to replace the bottom balances. I would need 4 however if the top balances are the same, I ... (cont.)

Need Balance.

I think I am missing the mortise set. Overall the handle is 5"x2.75" The mounting screws, center to center, are 3.25" The handle screws appear to be 2"L #8. The hardware could be Arcadia steel. I'd appreciate your thoughts.

The balances are shot they have the marking 34: On them. It seems like I may need to replace the plastic guides as well on a few windows since they are painted and sticky. Looks like total height is about 73.5" Are there sash frame parts available for order as well?

Need a pivot shoe, 9/16 deep x 1 1/4" wide. Hieght doesn't really matter. Just need the slotted top corner to allow the coil tensioner to lock in place

NEED THIS PART FOR A WINDOW THAT WAS INSTALLED IN 1979 NUMBERS ON FRAME OF WINDOW FRAME IS KAC-80-1 AND AEGD 06 1GCC CBA

Hi. I think I need the S385-21 but I am unsure if I need the S380 or S385. Can you please review the attached pictures and provide your advice.

Hi I am looking for a part for my windows. It's the roller that a window slides on.