Viewing all customer Discussions for:

Other

It's the front wheel assy by the latch of the door.

Marvin casement window, approx 56" tall by 21" wide, hinged on right, installed in early 1996. Window cranks in and out, but the locking mechanism is broken. It's a multipoint locking system with two keepers and a single locking lever. The two keepers are stamped "31787" and installed 39 3/4" apa ... (cont.)

I'm not positive what replacement parts are required. The window brand is unknown. Kindly advise if additional information is necessary. Than you for your assistance.

Do you have a replacement part for this. Complete unit needed. Thanks

Please let me know if you have these parts for both sides and any other parts I might be missing. Thanks

I have MW double hung tilt windows with broken balance tubes. I believe they are the same as the a ones above. I'm hoping the Series 795 channel balance are what i need. My old tubs have a length of 23 inches. The shoe is 1 1/4 wide X 1 1/2 high, the sash weight is 14.5 LBS. I have provided pic of ... (cont.)

Please help me find this part no. or the replacement for this. Thank you Bha

Hi there, The metal part measures 27'' long and ~1/2'' wide. The bottom fitting measures 1-3/32'', I think S350 will be an option, I am just wondering about the difference between S350 and S385. Thank you!

Looking for a white vinyl glazing bead as in photo.

The attached photos are the parts I need replaced but in white. Can you let me know which replacement parts I should purchase. I will need 2 of each. The crank has no. 45054 the lock has no. 30838 I look forward to hearing from you. Thanks!

These both came from the same window. They are 29 inches in length and 3/8 inch diameter. They are attached at the top with a simple screw and an attached clip at the bottom. The symbols on them are very faded, but look to read out as "GC B 1375". This could be incorrect however. ... (cont.)

Looking for this 9"casement operator.

I am looking to replace a Truth casement window latch - part #40902L (2 photos enclosed) Hopefully you have a replacement option for this. I send two images of the bent sash lock part. (perhaps I should simply re-bend, but I am nervous about strength and failure.

Looking for weatherstripping for a tubelite entrance door. Any help is appreciated

Last fall I contacted you about weather stripping for our Pella windows. I ordered the 58-055, it did nothing. Was I supposed to cut it at the corners, or go continuous around the corners. Do you think the 58-053 would be better

Window size is 25 X 59 I have other larger windows that Iwill need parts for. Do I need tosend add.photos? Thanks, Thomas

I am looking for a replacement hinge or just one that will work on the cabinet doors. The overlay is 3/8". Length front to back open all the way as in the first photo below is 3 1/8". The distance between holes is 2" on both the face-frame side, and the door side. Markings on the hinge are 348.229 ... (cont.)

Rubber bumper for Pella sliding door

Need replacement latch for sliding pato door. 2015 model with blinds inside windows. Vinyl trim outside, wood trim inside. The latch is golden brass colored. I can send pictures.

Please advise what I need to order to replace these. One picture has numbers and the name Caldwell. Thank you! PS I want to replace the whole piece