Viewing all customer Discussions for:

Other

Pella Patio french door Sweep in swing french door Purchased 1995-1996 Door Width 1 15/16" Sweep Width @ door Bottom 1 5/8" Space between inserts 7/8"

Pat. 5139291 white slide in about 2 1/2 inches long ,1/2 wide, 3/8 thick

The plastic end at the back if the guide has broken on some if the drawers.

Dear Swisco Experts: I need to replace 2 balance for this window. The metal frame dimensions are 1/2" x 26 11/16". It is an Extended Travel Channel Balance. The frames are stamped: 26-4. I would appreciate an identification of which balance is correct for this window. I also would like to ord ... (cont.)

Hi there - Hoping you can tell me which part I need. The only marking on these is in one of the attached pics. It says "26C", then what looks like "BSI", then written smaller and sideways "RN". Please advise. Thanks! Dennis

Measures 18" om the metal total 19" with both plastic ends.

Milgard around 2005, Length 19.7 inches. see pictures for stamp and end details

I need a entire coil balance part? Can you tell me where to find it and how much?

Hello! I am looking to repair a window in my home and need a replacement channel balance but do not know which to order. Attached are photos of the current one in my window that no longer holds the window up. I appreciate your help in guiding me to the correct product to purchase.Thank you.- Cecily ... (cont.)

Balances for Viking non-tilt window series 8300. Balance length is 27inches. Stamp 2640 with BS1 underneath

The lever broke to our slider

I purchased 10-118 roller bearing self locking rollers, they are too narrow to fit into the U shaped channel in an old IMC medicine cabinet manufactured by Berkowitz.Do you have a wider sizes?Thank youLen

Metal portion of balance is 26.5 inches. From a Milgard window about 20 years old. Measures 47x57. Weighs 30lbs.

Can't find handle for this door. Help!

Hi, I need a few hinges to replace rusted ones on my Milgard french doors. Do you have this type, or can you get it? Thanks, Louis

During the hurricane IAN almost all my windows come open even with the shutters on all because the tilt latches were old and hot Rodger. I was thinking to change the windows but if I can buy this item for this season.

reliabilt wardrobe door bottom rollers 0219942 do you have these rollers or similar have a wheel not concave

Steel Wheel O.D. = 1-1/8" Width = 11/16" Height = 1-1/16" No markings

The base is about 2.25 across. The latch needs to have a size of a .5 inch to fit between. Any recommendations would be appreciated

looking for complete replacement kit for center mount system that uses the #32-078 drawer guide Thanks Terry