Viewing all customer Discussions for:

Other

30 year old Weather Shield. Large awning. Crank arm channel mounted to sash is 26" wideThanks, Peter

Hi, I'm looking for replacement part for the Window Channel Balance stamped "38 5 FQ caldwell". Measurements for the balance is 38" long metal channel and 1-1/8" deep bottom fittings. Please tell me which one to buy. Thank you.

I did a really dumb thing and let the mortise lock fall into my door frame... Is there any way you could help me find a compatible part for the handle?

need correct model number

25 5/8" long Stamp 25 5 Millard windows I need four balancers

I am needing replacement hardware for this sliding glass door... God Bless

Krestmark sliding glass door rollers

It's a cylindrical thing kind of like a piston. Is there an extended version of same? Our storm doors are installed in such a way that they don't open past about 45 degrees, and I've heard that there are longer ones which would allow a wider opening.

Need replacement balances for 8 Weather Shield vinyl windows. Balances are stamped 28TG B.S.I. PO as shown in attached photo. They have blue shoes.

Hello Experts,I am looking for this part. Metal only length (workout end attachments like end guide or shoe set ) is 23.5 inches.Metal has markings 23 3 RN BSI TKI can share the photos. FYI , I am looking for two units. Nothing broken, it's just precious owner never put it. Thank you Kirti ... (cont.)

Photos from previous inquiry.

Hi, I have a set of roughly 10 year old Certainteed slider windows and one set has vent latches that have failed. I am trying to replace the latches but these windows take latches that are 3" long and I am having a hard time finding them. The ones that I found on your site are 2 1/2" long and I am p ... (cont.)

I am looking for replacement fasteners for my glass on my storm door

I believe it is a Larson storm door

Looking for a sliding glass door handle 1016 and 1014

Hello, this patio door is original to the 1998 construction but the brand is unclear. I can't find a serial number. The windows seem to match. Can you help us figure out if replacement with the same handle is possible, or failing that, a substitute that will not require new holes in the exiting doo ... (cont.)

number stamp on it is 7225 made by amerrock

Do you have any screen spline between .090 and .120 in diameter?

Please Id the correct replacement lock part number

The channel length is 25.5 and .5 inch wide. Milgard manufactured the windows. Stamp says 25 4 RK. Need 8 balancers for 4 windows. Thanks for help in identifying the proper balancer needed.