Viewing all customer Discussions for:

Other

I need to see if i can get a match for this style glazing bead. take a look and let me know what you think will work best. thanks

NFRC 100NAMICODE RIWSPEC NFRCSERIES WEATHERWELD DHMST 4060i need to replace two size rods for my windows, first measurement is 27in long string with a 20in long rod and the second is a 26in long rod with a 34in long string. it screws at the top with a single screw and the boot goes into the window ... (cont.)

Thanks.

Hello, I can't find any numbers on this guide. The part that is broken is the locking/release mechanism (green). It does indicate left and right but that's it. The drawer is soft close. The house is 13 years old. Any assistance is greatly appreciated!!

Hi Need single wheel roller for PGT sliding door in stainless steel plz. Thank you

Good morning, I am looking for this till window latch, both left and right. I hope the photos are adequate. Please let me know if you require any other information.

hinge broken. tilt in vinyl window

Need a set.

Trying to identify this Truth hardware operator for bay windos

Here are a couple of pictures of the hinge we need. I would like to get two. Thank you.

Have a sentry 2000 skylight operator with LCII controller. Can you supply a replacement controller or at least the board? What are my options?

The stud is missing from the end of this operator. Do you know if I can add the stud back or do I need a new operator all together. Thank you.

It is a Simoton Windows that is about 17 years old. Can you tell me what parts I should order? Thank you

both seal attached are approx 1/4" on the t-slot side and pile of the brush is approx 1/4" as well. The bottom seal on window is foam filled. 10 windows approx 28" wide 3 windows 22" wide

I think my sliding door handle has an offset lock lever but a centered key cylinder. Do you have something like that? The tumbler bar actually fits into the bottom hole. The holes are slightly less than one inch apart c/c. I can move the bottom hook with a screwdriver from the bottom hole. The top h ... (cont.)

Modu -wall. Is the only marking on it. What I would call a cam style handle is about 3.5 inches long. Mounts horizontal to the window frame the cam goes thru the frame and catches the small strike inside the window frame mounting holes are about 3 inches on center

Second of two emails to you. -DeFranco Glass

Need a replacement screen door track like the included pictures show.

Attached are photo of the parts that we need: Qty (4) 3250 balancers (metal length is 32 7/8" width is 5/8" Qty (4) 2640 balancers (metal length is 26 7/8" width is 5/8" Qty (10) sash shoes Qty (2) steel clips used to hold the balancers in place during installation. Please let us if ... (cont.)

It said 4HH in the coil spring. I am not sure which one ur selling can meet my requirements. Please help. Thx