Viewing all customer Discussions for:

Other

I'm looking for a more durable pull tab. The plastic ones in the photo function well but became brittle and broke after 3 years. The slot depth of the screen is 3/16". I tried Swisco 70-004 but they pulled out of the screen. Does your nylon part 70-128 last longer than plastic?

The right side window of our bay window has lost the seal and needs to be replaced. How do I go about doing this?This is a Truth window

The original patio door was manufactured by a Canadian company named Permanent Sash and Door. They went out of business about 20 years ago. I need to replace the outside handle and inside lock mechanism on the door. I've also included a photo of where the door latch hooks into if needed. Do you have ... (cont.)

Dimensions = 39-054 Except, the arm to hinge has 2 5/8" between screw holes

My windows both upper and lower won't stay up when I open the window. It looks like they both are out of the balancers as shown on the 2 photos I sent. Steve

I purchased new channel balance for my windows. The ends that are screwed to the window seal are different than the old ones. The new ones will not be flush as you can see on the photos. Will this make a difference when installed?

The only thing I know is the door brand is CertainTeed.

PART # 39-465 FROM SWISCO- BEFORE I BUY TWO OF THEM. DOES THE ONE I HAVE MATCH THE NEW ONE YOUR SELLING ?John

I am in search of a threaded cap for this latch. This part goes in a window screen & attaches through a hole. The cap & pin are threaded & screw in.

I am in need of two balances with the 19-024 top and 15-095 bottom fitting. Channel is 28in long.

Pivot pin Pivot shoe Window latch

I need to replace a few pieces of weatherstripping for my Traco windows. Mostly the felt type strips. I also need a couple of locking parts for the top of the windows. Thanks, Darryl Marx

This is a roller out of my Reliabilt sliding glass door. It has a V marking stamped on one side (see photos).

stamp on old balance says RN BSI TH

Good evening I need The whole assembly for 2 windows please advise if you can thank you so much

found your product says 5" but my original is only 4.5"

No picture yet, but can get one if it's needed...

Need l and R tilt latch

This door was purchased ca. 2008 from Lowes. I can't find any helpful numbers or markings on the door. I need to replace both roller assemblies and the track. I have attached photos of the parts with measurements. Thank you for your assistance.

SA 409 is stamped on the metal coil. what coil weight is needed for this 3/4 inch wide coil. and please let me know how much it costs.