Viewing all customer Discussions for:

Other

I need aluminum window glass glaze bead shown in picture

I have these plastic parts at the end of my metal drawer rails for a kitchen drawer. One of them has broken and I need to replace it, but I can't seem to find something that will work. Any help would be much appreciated.

Hello Swisco, I will be ordering American Craftsman parts for my windows and door slider 6' can You tell me the correct slidder wheels forthe 6' American Craftsman Slidders? I will be ordering also American Craftsman Double hung parts Pivot pins, Coil Balance Springs 16.7lbs window weight and Ti ... (cont.)

Plastic piece that squares the window. 4.5" x 6.0" 101/IS 2-97. Need the long piece. To start with. Still looking into other issues with the window not staying up. Thank you! Maria

Hello,Can you help me? I am looking for replacement rollers for my doors. If you can identify and provide me with the correct replacement. Looking at your site it looks like a 81-023 it has a 1 1/4 wheel. I would need 8 -10.Thank you Greg

My window is jammed in the fully closed position. I noticed some pieces of broken plastic when I locked it. I'm not sure how to remove window now that's it's jammed closed. Do I remove the terminal clip and try to pull the window up? The markings on my channel balance are 26 4 6V CMC 1 and the leng ... (cont.)

I need a replacement for my window as the one pictured I upload snapped. Thank you! Tamra

Hi, I need the slider track and brackets for a 92"L x 39"H SWC Vinyl Window, Fixed center, with a horizontal slider on each side. Can you help me find the parts?

Hoping to find these. I need a complete set. I'm missing one of the pulls.

Body is 1" tall, 3-1/16" long, 11/16" wide, and wheels (double) are 1-1/4" diameter, made of metal. Door is a Pella and approximately 18 years old

Looking for replacement slider door handles - outside and inside seem to attach. There is 4inches in between the screws.

These windows are 50-60's vintage. They are double hung with aluminum jamb liners, that sound like they have springs inside for counter balancing. The front of the aluminum is crimped onto the back and I cannot easily access the springs with out bending it apart. On most windows the metal wire wh ... (cont.)

Need to replace a total of 6 channel springs size 26 30 and 6 size 15 20

Do you have 4 of these? also do you have secondary piece that holds the roller. In photo, it has the screws and I'm not sure if you have this part.

This is for wood Incase window I'm not sure if the crank handle is missing or broke but I need to replace four of them lefts and rights i believe there 11" and if there not broken do u sell the crank only thank you

Need to buy same channel balance as the photo

Hi. I'm looking to replace the hardware on a sliding door. The attached photos show the existing hardware. Ideally, I'd like to get hardware that includes a key lock, but I'm not sure anything like that exists. Any help you can give would be greatly appreciated.

12 2 bsI

D61-7/27 can you help me with a replacement number please

Dear Sir or Madam, some of my frinds window balancers are broken. Could you please help to identify which replacement balancer works? The size looks like 9/16 x 1 1/4. On the coils, one is marked "5", the other "6". The weight of the window is 20 - 23 pound. The height is 36 ". Thanks, Andreas ... (cont.)