Viewing all customer Discussions for:

Other

In my green house I have 12 Windows the balance # 2330:

Old 1994 EPI window. 32" channel 5/8". Got four of these laying around????

Need 2 sets of sliding glass door handles and locks SILVERLINE MARTELL 2 hd 295-848 pd mortise lock 2 11-PM526A GEMINI 2 POINT LOCK W/COVER PLATE

What is the correct part # to order? This is a two coil balance. Size is 1 1/4 x 9/16.

Can you tell me if you have the coil balance for bf rich cabernet series (35" P 232208)

I have 15 Crestline Millwork windows that need a gear. They open, close and lock except when getting to the section of gear that is stripped. Lock is separately located. The gear is 1" diameter with 15 teeth. The operator mechanism with the gearing and crank is 4"x2". The exposed arm is 15". There i ... (cont.)

Good morning,We are looking for some replacement sliding door rollers for our boat per the attached photos. Let me know if you need any additional information.Thank you,Deb

I have one of these a clips that snapped. Before purchasing a new one I'd like to know how to install. It looks like the original was built into its frame for my Harvey double hung. I don't see an obvious solution.

I didn't include the picture but the width is 1/2"

Lee has three windows that need new channel balances. The photos are of a 2040 balance that measures 21 inches long. There are two windows that use a 2640 balance that measures 27 inches long. I have a couple of other photos, but reached the upload limit. I will send them on second upload. ... (cont.)

Possible patent#5139291 .75 Bought slim top tilt latch #26-391. It is much thinner then mine. Will the thinner one work

not sure how to order 35 inch length with shoe ass shon

Is a wheels that run in top guide

The part that goes up the side of the casement window that allows you to lock the window fell down. My name is Pat

I need 2 new channel balances and can't quite figure out what part matches. The brand is IWC (Internatioal Window Co.) The length is 27 inches (just the metal). The markings on the side are 26 4 EU CMC 2. Can you please help by letting me know which of your parts is a match? Thank you! ... (cont.)

Need 2 rh and 2 lh cranks

We have 4 sliding glass lock sets we are looking to replace as they are now sticking due to corrosion from salt air (near beach). I do not see any numbers on exterior (see pics)

Hi, I am a local window installer . I have purchased window parts from you in the past. I will send you a picture of the rod and tackle bounces that I have. I know they are discontinued. I was hoping you could match them up with something that will work in these windows. Let me know if you need any ... (cont.)

The above pictures are of a good balance installed in window. The rod in the middle of the spring is 27 1/4". The sash height is 28 3/4". The lock mechanisms are fine. The block and tackle need to be replaced along with spring and rod. Thank you for your help. Scott

DO YOU HAVE THIS PART?see photocounter balance 26 6 AV CMC 2I measured the metal only:1/2" by 27"