Viewing all customer Discussions for:

Other

Hi, The handle fell off our sliding door. We do not know the manufacturer of the door and would like to identify a replacement part. I'm attaching some photos of the handle and the door. Thanks!

The screen door handle is old and should be replaced. The latch the opens and closes the door on thenback side of the door opener is broken off. I want to make sure that I am getting the right part.

I need a pair of an unknown brand of Tilt Latchs, with tilt latch finger levers. Attached are photos of the broken one. It has a 2 5/8” housing length, and is 11/16” wide. It has a “75” marked on the housing. The tilt latch finger lever is 1 3/8” by 7/16” deep. ... (cont.)

Hi, what style of tilt latch do I need?

Hi - I think I have figured out the other parts I need, but I am not sure on what coil I need for this triple coil replacement. So far, I got the covers (15-205) and the pivot shoe (15-199). On it, the coils says #4.0 35. Does that mean this one: https://www.swisco.com/4lb-Series-165/pd/Series-16 ... (cont.)

I am looking to replace a pair of block-and-tackle (channel) window balances from a non-tilt aluminum single/double-hung window. Details: Balance type: Block-and-tackle / channel balance (non-tilt) Stamped marking (partially visible): “33.5 JT CMC 2” Metal channel length: approxima ... (cont.)

I'm looking for the sliding door track for a International Window Corp. door. From what I understand, they are no longer in business.

Opens left, there are numbers 20810 on one piece and 30744 on another (see pics) Unit is approx. 35 yrs old, and the crank screw is worn. Pic 3649 is best shot of whole unit. Randy Larzelere randylarz@gmail.com

Can you help me identify a replacement latch for these windows? I measured them to be roughly 2-5/8" in length.

Connects to metal roller and ensures smooth close. 2.5 in by 3 in.

I know I have purchased these parts from SWISCO in the past but can't seem to find the part again. I have 2 corner reinforcements that have failed. They are made of plastic and fit into the corners of the panets to prevent the door from sagging. Needless to say, the door is sagging. ... (cont.)

Slider circa 2004. Dome head bolt spacing = 4" Only marking: Patent Pending

See pictures. Bottom boot is 1 3/32 deep. Metal length is 32" 1/2 inch channel. Window weighs approximately 25 lbs (maybe slightly more) I'm thinking the S385 but want to be absolutely sure.

I have double hung tilt windows that were installed in 2002 or 2003. Parts are starting to fail and need the tilt latches and other parts as well.

Part has 0910 imprinted on metal pieces

Please help me indentify this balance.

Google Lens said it might be a Blum soft close hinge for a kitchen cabinet door. Can you help?

One of my window sashes doesn't stay in place and keeps sliding down. These windows were replaced before I got the place and have no markings for the manufacturer or the coil mechanism. Attached are pictures from the broken coil spring (both sides are broken and the coil is out). I've attached a pic ... (cont.)

Could you please help me identify the correct 25" channel guide? Thank you!

I would like to try and replace only the bottom window sash.