Viewing all customer Discussions for:

Other

Harvey advised that these latches have been discontinued and referred me to you to find replacements.Attached are pictures of the product label and the two broken latches.(They were intentionally broken by police to gain entry in a medical emergency.)I hope you have suitable replacements.-Dennis ... (cont.)

I new two new replacement balances and a couple clip releases

plastic guide on window frame

Trying to replace window channel balancers 28 inches long Marking on the side reads: 27 3 B.S.I ON

Can you help me with replacing this weatherstripping? One is for sliders, the other is for French doors.

I need the mechanism that goes on the side that the glass goes into.

patio door wheels need replacement part number

Good afternoon. I'm trying To find this plastic piece that is screwed onto the top of both sides of the windows. They are all around 20 years old and dry rotted and breaking cashing the windows to not stay up and fall down. Does your company happen to carry these parts or know where I can find them? ... (cont.)

We have these awning windows 58" X 34", interior wood (pine) exterior metal clad in a home built in 1999. The manufacturer is unknown to us. We may need new round knob crank hardware as well as screens and gaskets. Can you identify the product? I found no glazing stamp to go by.

Looking for roller assembly as shown in picture. Similar to your Sliding Patio Glass Door Tandem Roller Product Code: 81-018 except that my wheels have flat edges instead of concave edges. The door model is PATIO DOOR LEGANCE II, PRODUCT LINE #: 213? K. 018

These window supports are available it is the pin that it attaches to is the problem. As you can see in the picture, the pin falls out clip still attached. Any ideas on how this could be reconnected? Some of them are gone, maybe could be fixed with a screw? Any help would be appreciated.Thanks,Terry ... (cont.)

Unable to find manufacturer. The track is 5/8 wide and the "rail" is "1/4-5/16" high.

25 1/4 Metal Channel, Stamp 25 4 Not sure of the Manufacturer of the window. Also looking for the same type of Balances- Metal channel 19 1/2, Stamp 19 5,Metal Channel 29 1/2 Stamp 29 4Thank You

We have a very large heavy mirrored closet door that is no longer sliding properly in its track. Local hardware stores do not have the correct size. We figure the door is circa 1985. We need four (4) replacement rollers.

28 INCH METAL CHANNEL 279 BSI re ORDERED DEC 2005 PUT IN EARLY 2006 CUSTOM WINDOW SYSTEMS VINYL FRAME please make two

My window lock is broken.

Are these locks available in left and right

I need to replace the hinge, you can see where it is broken. One side had the number 511.217.00.00 and the other has 554.317.61.1C. Not certain on the 61. Is still made or do you have a suggestion on replacement part? Center hole distance on inset side is 1 7/16" and other side is 1 1/4"Thanks,T ... (cont.)

my crank out windows locking parts broke off so I can't lock my widows shut. I tried to upload a picture, but was unsuccessful. it was the plastic parts that broke off. Pam

Need to figure out which series I need to order; from the website, I believe they are either 380 or 385 but unsure how to determine without removing everything which I'm not ready to do?