Viewing all customer Discussions for:

Other

Good morning,I'm looking for replacement for those rubber seal around the window opening.Pictures attached. Thank youVitor

I received the rollers I ordered. Unfortunately they are slightly bigger than the current rollers. I'm attaching a picture, looks like an 1/8" too big. The wheel itself is 1 1/2" I saw the model 81-261 was wondering if that might work?

I need instructions on how to install 15"385 channel balances on old windows! Not replacement instructions!

I believe this is coming from a 1/2 34 window balancer on a Regency window probably installed around 1998. Just looking for two replacements

i need 4 of these balance shoes. I look forward to your response. my Best, Mike

We would like to order 12 of these.

Hi. I am willing to purchase some replacement for my broken window channels. But I am not sure which I should buy. Could you help me identify the parts? Additionally, I have couple questions to the SWISCO. What is the return policy if the parts I purchased doesn't fit? How long will the order get s ... (cont.)

Can you please help identify these parts the windows are in good condition but just won't stay up. I need 5 left and 1 right. Please let me know what you think.

Sliding closet doors, bottom convex rollers 1 1/4" dia. No markings on hardware. Looking for a replacement.

Any help with this style of window glaze strips?

convex roller bottom track need 6'

Replacing IGU in older wooden window lower sash and the glazing trim strips did not like being removed. Looking for replacements. The strip is a 90 degree type with 3/4" by 1/2" wide sides. two small ridge strips to lock it in to frame. I'll upload pics if see where to attach it. ... (cont.)

Hi. I am replacing the wool pile from the aluminum windows from my 1963 home. After 6 decades, they seemed to be worn out from the harsh extreme Las Vegas heat after 6 decades. it has a metal / aluminum backing and is 1/4" wide and 1/4 inch high, but I'm thinking perhaps the height should be higher ... (cont.)

Do you sell Pella window parts? If so, I am looking for the locking mechanisms for a casement window.

Hi, I have what appears to be an H-R single hung sliding window with dual spiral balances on each side that are broken and need replacement parts. I can't find the manufacturer and assume they are out of business or have been acquired. Can you help with parts?

Looking to replace the top and bottom parts for a curved shower door which is in two parts, original part information on the doors is as follows: - King Glass, Tempered Glass ANSI Z97 - 1 - 1984 19 CFR 120 1 C11 CAN/CGSB - 12 - 1 - M Need to replace both upper roller

How do I determine whether to order series 600 or 900? My existing balances only have one "t" at each end. The tip is red. Thank you for your assistance.

I believe I have a PGT door and the 81-020 roller looks like it will work. Can I get your opinion on this ?? Best regards, Mike

I'm working on putting a doggy door into where we have a casement window and can't make a full rotation of the window crank because it hits the bottom of the plastic frame on the doggy door. I tried measuring the diameter of the shaft and ordered a 4" extension for 11/32". This turned out to be too ... (cont.)

I'd like to replace the window balances in 3 windows. All have the same top and bottom plastic parts. The photos are of the longest at 37" with 3640 stamped on it. I have a 35" with 34-9 FA2 CMC 13 stamped on it. Then a 30" with 29-91675 stamped on it.