Viewing all customer Discussions for:

Other

I have a need for part number 60.1890 approximately 20+ pieces. Track is fine. Do not see this part on your list.3/8 x 1 is the opening. receiver is approximately 2 1/4 ". Remodeling a kitchen, hate to buy all new glides if not needed. Thanks, Ron

This is a hinge on a Milgard door. They referred me to you.

Hi, I've attached photos: - One of a metal clip-like part (I don't have a photo of it in place, sorry)- Two photos of a plastic part--one in the window mechanism and one that is broken off.These were located when we replaced Series 385 channel balances in four windows (three 33" and one 27")and we n ... (cont.)

I need both left and right window coil balance replacements including the pivot shoes and standard support. Pls help. Ty

Hi There I want to weather seal my front door, but there is a gap. What can I replace to seal the gap? Thanks! Malisa

5/8 Caldwell 22-4 Single hung window balance

Do you have OEM sweep that can fit the channel on the bottom of this door?

Trying to find a replacement part for the bottom locking mechanism on my Plygem Classic Sliding Door. The part says it was manufacturer by Vanguard Plastics.

Hi - I'm looking for replacement WS. Kerf looks to be 3/8" wide so wider than normal. Hinge side strip looks to be vinyl and handle side is magnetic. Vinyl is probably cheaper but mostly concerned about the right size fin to fit into the kerf. Kerf is located on the side of the door jamb which i ... (cont.)

metal wheels, 1 inch and 1/16 diameter wheel, 3 inches long

82218 is close but note rounded face plate is 4 1/2 in length and mounting holes are 3 5/8 on center.

Hello. This (and a few identical windows in my home), will no longer stay up on their own anymore unless I prop the window up with other supports, which is annoying. I can't find any part numbers, the label shown is from the inside top of the upper window and I believe they're all original windows f ... (cont.)

Hi, I'm looking to replace the finger hold piece of this if possible, or the entire piece if necessary. Thanks in advance for your help!

have m & w window -- need pivot shoe --will buy balance as well--is their a place where i can go and pickup in my area? or person that will do job?

I would like to purchase (2) S390-16 for a 23lb window.

Not for screen door. It's for the slider glass door

Picture shows broken plastic piece on top.

Used on a patio screen door vertically as the seal when the screen door slides closed. I used a caliper to get the dimensions, so they should be close. Need about 10'. Thank you Darren

Windows are series 300 H-R50-44x72 aluminum

Good morning, I am trying to order the correct door seal for this door. Thank you Martin