Viewing all customer Discussions for:

39-092 ROTO Casement Operator

Need to replace my milguard casement hardware. Window does not close.

I have measured the hex bolt this attaches to and it appears to be 11/32 Would I be right in that? 5/16 seems to be fractionally too small. The casement window this handle is for is about 10 years old.

The mechanism is longer opening the window. I don't know the window brand and I don't have any serial numbers. I need left and right opening mechanisms.

Hello, Are you able to provide a replacement Window Crank Operator like the one in the pictures. NOTE: One in picture is for right-hand window; need one for left-hand. Thank you! Brian

Hello I'm looking for parts to replace old window Hardware. It is Roto manufacture but I did not quite find match using the number on ARM. I would like to get new operator, the arm and optionally the bracket from image 3208 (as it is getting old and broken as well - just the plastic) Please let ... (cont.)

Both the top and bottom assemblies are rusted and broken. I would need to replace both. Do you have a part you could recommend for top and a part for bottom?

I am looking for these operators in bronze, are there any bronze available?

43/4 IN CENTER TO HOLES . OPERATOR IS 5 1/4 INCHES WIDE. SPLIT ARME 3" AND 5"

the operator arm measures 3 1/2 inches

Hello, There! I am looking for Milgard 3510 Casement Operator and Handle. The part number for the operator is HA0391OPCY (Operator RH 3510 Clay). Handle would be HL0137CY. Hope the pictures help.

I'm looking for the arm in the picture. It will (or should fit) on your part # 39-092. It's 5 3/8" long and the small square swivel piece on the end which measure 5/8 X 5/8 has a piece cracked off of it and no longer stays in the track on the underside of the casement window. I bought your part ... (cont.)

Will need at least 2 buy up to 8

I have Milgard windows throughout the house. I believe they're between 8 to 10 years old. I need a replacement upper casement operator for my Milgard window could you please let me know what I should order. SERIES: 3510 casementPRODUCT LINE # 232-167Please see photos below.Thank you, Dan ... (cont.)

Hi looking for LH and RH

Hi have crystal window need crank assembly /arm to open and close window

Hello could you help find new cranks for these windows both are broken. Thank you

The ferrule acts as a bearing that the hole in the end of the arms attached to the bottom of the window rotate around. The ferrule is broken so the arm attachment point is loose and gets hung up on the broken ferrule and you can't get the window closed without a lot of manual manipulation. The scr ... (cont.)

These Solar Industries Inc. windows were purchased in April 1999 through Home Depot. The window mechanisms seem to work fine except that the hand crank part is breaking on all of them. There are five, 18x60 windows in total. I'm attaching photos. I would like to know if you have the parts available ... (cont.)

This is the photo's on my window crank. The only other thing on it is INTERLOCK world patents made in new Zealand.My name is Tom Seaway company sent me two arms which are about 1/4" To long. That is why I sent you the picture of the arm measurement.Thanks in advance. if you call my home and no one a ... (cont.)

I need this in white (1) and 2 in Almond (RH)