Viewing all customer Discussions for:

39-092 ROTO Casement Operator

I don't know the window manufacture these are older window and I need new cranks.

The part in the last photo says. P4000 Made in New Zealand Patent pending I'd like info on and the 2 arms that connect it to the window. Thanks, Doug

Do you sell a folding crank handle that folds up so the handle won't block the shade. These are Millguard windows

Here are some pictures of my windows, they are roughly 25 years old. There are a few that do not work, parts have broken or rusted. I want to work on replacing parts so windows will work. The upper and lower tracks are roughly 10 inches. The width of picture ending in 354 is roughly 5.25 inches. The ... (cont.)

I'm looking for a replacement crank assembly. The markings say "Roto" "Interlook" made in New Zealand.

Need help in getting this part

This is for a milgard window. The window is 20+ years old. I have contacted Milgard and they no longer make or have this part. The gears appear to be striped. Hopefully you can find something that will work for me

Hear stripped

Donna- need help finding a new cranked

Hi! Our casement window (if inside facing the outside, the right side), was damaged due to wind, causing the hinge to break. Here is the information we could find:Roto G2-STRKR-12These are the measurements that we found ourselves (not listed on the parts)9 3/4 inches attached to sill7 inches on the ... (cont.)

Hello. I have one window that needs the part that makes the window open and close. See photos. Hope you can help. Thanks very much.

Hello. I am looking for a 5/16 hex window crank for 7 Milguard windows. Would this handle work?

Roto component that cranks open the window outward on a hinge.

Hey folks, I installed this right hand opening casement window in 2001 for a client. A little bitty attachment piece on the window where one winder strut attaches done broke. (Windy place) I kinda assume I'll need an entirely new winder, but not sure if where it attaches and where it broke would be ... (cont.)

There are no company designation on the pieces. There is an "A" and "B" on the arms for LH/RH. The hinge point/pivot on the bottom of the window is unusual, it has mating parts that can be adjusted left and right on sliding/serrated surfaces. Any help would be great. The customer would like to g ... (cont.)

Hi, my name is Robert. I need a new operating mechanism for a double hung window, I need the piece that to the bottom of the window as well as the hand crank mechanism.There are no markings or numbers on any part of the window so hopefully these pictures will help you figure out what I need.Thank yo ... (cont.)

Hi there I've attached pictures of a crank handle and the crank. I just need the handle. Please help.

Markings ROTO Interlock world patents Made in New Zealand Design pending

Hi, I would really appreciate your help figuring this out. These are located at Carolina beach (1.5 blocks off the ocean) and have garnered some serious failure. We jsut bought the place a few months ago and pretty much all four windows need new hardware (top and bottom hardware.) I found some old ... (cont.)

I need a handle (old one is stripped) for a casement window. I have a 5/16ths ratchet fitting that fits perfectly. I bought a handle with 5/16ths bore and it would not fit.