Viewing all customer Discussions for:

39-114L Crank Handle, 11/32"

it has a G-U symbol with two diagonal arrow heads next to the G-U. The first arrowhead is larger then the second one. There is also a clock of some sort that has an arrow pointing towards the nine.

TRUTH window closing mechanism for casement window 70144. The gears are stripped. The arm length is about 9 inches. I hope you can help me.

We have these awning windows 58" X 34", interior wood (pine) exterior metal clad in a home built in 1999. The manufacturer is unknown to us. We may need new round knob crank hardware as well as screens and gaskets. Can you identify the product? I found no glazing stamp to go by.

I need some Ellipse cranks with 13-1/2" arms per this photo. 3 pcs for LH casements in white.

The handle needs to be replaced as it is slipping

I have quite a few broken plastic covers on my window cranks. Inside the cover says Truth (see photos. I would like to replace cranks because a lot are broken and also to have a lower profile. I have attached pictures that show what it looks like and the inside. which crank should I order. ... (cont.)

I have 10-20 Ply Gem casement windows that have rusted crank mechanism parts that need to be replaced. Some are rusted others are fractured do to rust. ( we're on the ocean) All internal parts are intact See attached scan

Looking to see if you guys can help with this. This one doesn't crank properly. Looking for new. Thanks.

I need 1 replacement crank handle for a Hurd casement window, installed in 2000. This handle pushes onto the splined shaft of the operator, and has a spring clip to hold it on--no set screw. In the end view, you can see the splines and the spring fitting into the slot. In the slide view, you can ... (cont.)

I am looking to change the hardware to white in my window. The lock mechanism is marked Truth, Made in USA and 40226. I believe these are sash locks LH:38-097 and RH:38-098 I also need covers and cranks. 39-107, 39-114L Can you verify I found the correct parts? Thanks, Tom

This photo attached is the right hand casement hardware I would want to replace. It is for an American Craftsman window model 3100 which is no longer available.I want to get 2 right hand and 1 left hand.You can call me if there is an issue finding a replacement.My name is Joey Please email me with y ... (cont.)

I have rusted out hardware on my single awning windows. I have added pictures of the parts we removed. There are 2 locks per window, with the white levers. There is one hexagonal metal piece with a handle that opens the window. And there is a separate metal unit I placed next to the locking mechanis ... (cont.)

Hi, I need to replace a window crank approximately 5 1/4 from left to right, the arm is approximately 8 inches when extended. Do you have a replacement? Picture attached. Thank you!

Looking for the crank mechanism and arm for this left and right. Also the accompanying lock and bar for the right. Thanks

Can this handle replace existing handle on 39-031 and 39-032 dual arm operators? Bob

Hello, My name is Tom from Glass Doctor of Western Seattle. I have an order that I am trying to complete for a current client. These are single arms that extend on Right hand side (Inside looking out) I will also need a new track for these as well if applicable? We are thinking of an order for the b ... (cont.)

Window will not open or close completely when cranked. Crank is located on the right side when viewed from the inside out.

Hello, We just purchased a run down house and have noticed that a lot of the vinyl windows are going to need either or both their operators and covers. We cannot find any manufacturer names on the parts and would like to know what brand we need to buy. I will send a couple of photos of what we hav ... (cont.)

hello i am looking for hadle for windows

Looking for replacement parts if you have any