Viewing all customer Discussions for:

39-114L Crank Handle, 11/32"

Stamped "truth" on arm. Window hinge is to the right. Screw holes are 3 1/8 " center to center. Hinged arm

Hi, I'm looking to replace the hardware on 6 bay windows, side hung, outward opening. They don't have any markings or brand names and are original to the house built in 1976. I can take additional pictures of the window locks but I would prefer not to remove the openers until I'm sure I can find a r ... (cont.)

Good morning. I need both Left and Right casement window operators per the attached photos

I'm hoping you can identify these parts or tell me what to measure?

For a casement window, numbers on it include: 12182003 0820 45251 40050

The right hand mechanism has a rusted swing arm. I would like to replace both of them,

Hello Swisco! We have Pozzi casement windows and one of the operators isn’t cooperating. It’s a left hinge, right opening window and the operator cranks counter-clockwise to open the window. The long arm says EntryGard Truth. The window opens and closes until the arm reaches the arrow on ... (cont.)

The white part is 4 and 1/4 inches. For the grey horizontal, the measurement from where the diagonal begins on the white part it’s 3 and 3/4. But from the middle of the white part to the end of the horizontal part it’s 4 and 3/4. Then the grey diagonal handle is 3 and 3/4 ... (cont.)

I hope these photos are good enough

Hello, I need to replace some left and right hand window operators with cranks

31850 is the number on the window hardware

Replacement window screens - 8 (Windows 1,2,3, & 4) Replacement Window handles - 4 (Window 1 - left and right 2 handles, Window 2 - right handle and Window 4 - right handle

The crank is 4 inches long and 2 inches wide.The arm is nine inches long.No identifying marks.Will need one for left and one for right window.ThanksFrank

Hi, I was wondering you could help me ID replacements for the attached photos.Thanks, Matt

This is an EAGLE window from about 2010. The gears are stripped. The width of the opening in the sill is 5inches and the height is 3/4inch. I can take more pictures if necessary. Let me know.

One of the gear teeth is wore off and won't engage. Hoping to find an entirely new replacement mechanism.

Im working with a school district to change out operators that no longer work. I cannot find a part number on the hardware so Im hopeful you can help us figure out what I need to order

Inside the crank handle was the number II 45054 The cover is 5" wide by about 1" tall. when closed the arms are a total of about 24" wide (as they sit inside the sill when closed)

Need replacement knobs 10 total

House built in 1995. The gears are stripped and I need replacement hardware The only number I see is 30744 and its on one of the hardware arms.