Viewing all customer Discussions for:

39-517 Clip-Stud Bracket, Right Handed

Need left hand (viewed from outside) sash hinges - pretty sure these are 10" 2-bar but want to verify. they say Truth EntryGard on them. Your P/N 36-048? I want to replace both upper and lower. Please confirm... one source says a lipped casement window requires a 4-bar but doesn't look the same as ... (cont.)

Looking for advice on my casement window. I have several window that open easily but cannot be closed, especially the last inches of two before they close and are latched.

I have a bay casement window in my kitchen and the crank mechanisms are done on both sides so I am looking to replace. It appears that product 39-155 (and 156) are the mechanisms I need. Do you agree based on the photos I sent?

truth casement window long arm: 8.5"- 8.75" (still installed, difficult to get an arm-to-center measurement)short arm: slightly less than 4"hinge: 10"-11" (difficult to be exact with the rust)

I need to replace the window cranks on several of the casement windows in my home. I hope the photos attached give you enough info. to know what I need to buy.

Left and right I need the complete assembly

I have an older crestline installed window. The crank is no longer working - can't open or close the window. It has a pin that should go in to line up with the gears so the crank will do it's work but I cannot get that back in to its correct place. I am wondering if I should just try to get a new cr ... (cont.)

Which operator do I need? Casement window is 27" wide. Short arm 4 7/16" Left handed. Is it returnable if the repair man to fix broken glass has an operator in stock?

I think your part number is Product Code: 39-031 EntryGard Dual Arm Operator but I am not sure so call me

The broken crank has a 9" arm and a smaller arm. The long arm is stamped Entry Gard Truth. I am hoping to only have to take this apart once but if you need a number or code tell me where I can find it and I will do my best.

Please see attached. Thank you, please see attached photosof each of 2 operators. The measurements of the pieces for each operating unit are as follows (inches): 5.75 11.5 8.0 And 4.5 11.5 9.0 Thank you.

Hello, need to replace three window cranks, but I have eight windows and I will purchase five additional cranks. The name brand is Lincoln. Each hardware has two cranks and one maybe two brackets that extend to open the window. The top bracket has two numbers: 1. L30841 2. 20810 The second bracket ... (cont.)

The main shaft that run the opener gear detaches and screws out of the housing

Missing the bracket and screws for this Semco window. Trying to identify the parts for it.

Need the casement window operator for these windows

I have 3 window cranks that broke and need replacement. Can you identify the right parts for replacement so I can place an order. Let me know if you need additional pictures Thank You

Hello - I have four windows with the attached hardware that is not working properly on any of the windows. Was looking for help to identify the proper replacements. Thanks!

How can I access the screws to replace the hardware for 37 year old Marvin windows? It looks like the wood covering part of the base would need to be removed. Thanks

#31538 on one of the crank armsNeed left and right

Hello, Please help to match a part number for Truth Entry Gard, I measured the short arm ( 2 7/8 Inch ).