Viewing all customer Discussions for:

40-049 Complete Mortise Lockset, Brass

Do you carry matte black finish?

Will your lock case 40-194, fit on my door, the only difference I see is where the lock mechanism goes into the lock case see pictures. Thank you Bill

Does a strike plate come with this assembly, or is there a separate part number?

Made in Brazil. 0796 Either FADO or PADO

Will the 40-049swisco lockset replace MTS 323 lockset

Hello, I have a Cole-Sewell storm door, probably from the 90's. The lever has broken. The metal nub that kept the tightening screw on has worn away. The inside back plate measurements are approximately 8.25" x 1" What replacement part would you suggest? Thanks

It's a papaiz lockset. Do you carry anything similar to this

Hi, the cats lost all of the screws for my storm door latch while I had it disassembled to polish the brass on the benchtop polishing wheel. so typical. and I will never learn. so it's time for a nice new replacement set. Could you please guide me to one that will fit.

Attached are several photos of my old Dado (approx 25 years) lockset. I think your part number 40-049 might be the correct replacement for it. Do you agree? My drawing may be a little rough, but hopefully it provides the information you need. Let me know if you need anything else. Thanks for your h ... (cont.)

Measurements In pictures above

Like to replace handles and plates or whole lock set emco

Picture shows left opening. Cane it be changed to right hand

Hi there, Trying to find a replacement for the door hardware pictured. Writing on the side piece is Juralco 322. Would like to find silver or nickel replacement. Thank you Mary

Hello, I spoke with one of your representatives recently regarding the need to replace an older storm door handle. The door handle manufacturer is Emtek, with the model number of 322 (image4.jpeg). It was suggested to send photos - I have attached photos of the handle attached and removed. thanks ... (cont.)

I need a striker plate to match lockset code 40-049. Is that included in the complete mortise lockset?

Hello, I have attached some images for our current storm door lock (A), and we attempted to buy a replacement (B) but we were unable to screw in the replacement to our door. We are looking for a specific set that fits our current lock (A). We need help finding a replacement that fits the holes we ... (cont.)

i have a sears storm door need replacement lock

I am looking for a storm door handle from and old Cole Sewell door. It is a Wright handle and I am sure quite old. I have attached photos.

don't wish to disassemble in the very, very immediate future unless absolutely required for I.D. "tongue plate" @19cm long (metric rule in photo)thanks for your help, mark

Storm doors handle kits 35004102. 372080604