Viewing all customer Discussions for:

10-109 7/8" Flat Shower Door Wheel

I am looking for replacement drawer slide for the provided photo item. Also, individual rollers, if possible.

Steel Cabinets from 1972. Drawer wheels are plastic, possibly nylon, outside diameter 15/16 inches, Wheel rolling flat surface is 1/4 inch wide and offset from steel surface by 1/8 inch, mounted into a pop in hole, and hole diameter is approx 5/16 inches diameter. The wheel rotates on a plastic cen ... (cont.)

good morning: Earlier I sent you desk drawer right side rail which is good. Please see the attached pictures of the desk drawer left side rail from which the wheel broke down. The rail is 20 3/4 inch long, 1" wide tapers to 5/8 inch at the bottom, wheel is 7/8 inch diameter. I can buy the whole ra ... (cont.)

Need to find replacement rollers. These seem to be worn allowing the drawers to drag. They are part of a Knapp & Vogt slides made in Grand Rapids Mich They are about 7/8 inches

Scheirich kitchen cabinets from the 1970s. Looking for replacement hinges. Cabinet frame is 1/2" thick. Door overlay is 1/4". Also looking for roller assembly brackets for the drawers - US Patent No. 3,980,364. Thanks.

Actually I only need one

The slide in the picture is from a Wood-Mode kitchen cabinet. 22" slide Roller style is round, with is 1/4", diameter is 7/8" ( The worn rollers are ball bearing type) Looks similar to your 10-101 roller?

Please let me no if you have this part

I need two sets of these roller brackets

I have been trying to find these high quality shower door rollers. They have nice rubber around it and ball bearings. I have found plastic replacements but they are not as good. The rubber helps for smoother glide. They are 7/8 inch in diameter. Any suggestions?

The glide is 16 inches long and the roller is about 7/8 of an inch. It says GRANT 338 on it.

the plastic wheels at the ends of the rails are broken. Is there a way to replace just that paryt. if not, where to get the rail. Thanks p.s. pic is upside down, obviously alan

I think this part is Swisco's 10-153. Which is perfect EXCEPT the post inside the glass holder is isn't deep enough.. the 10-153 post is about 1/2'" from the top of the the glass holder. The center of the hole in my shower door glass is 3/4". o you have this part? If not do you have anything else ... (cont.)

I have a closet bi-pass sliding metal & glass door setup that I need replacement parts for (5 photos attached & have more photos) and I'm having no luck finding them!

Wondering if you have a roller like this? See attached. It is for a sliding glass door.

Hello! One pic shows intact wheel, the other shows metal hub needing replacement wheel. Plastic wheel measures 1" in diameter, metal hub measures .5" in diameter. Will a replacement plastic wheel snap right on?

I have two pictures of the parts I am looking for or a replacement that will work. The corner clips are a clear plastic with rollers offset

I will require about 10 of these screws which appear to be 3/8 of an inch long and 5/16 in thread diameter. The white nylon guide bushing appears to be 7/8 inch diameter or so and I will need four of those.

Jackmorr 24"×2" drawer slide

This appears to be a Grant track system. I can see in tiny letters, Grant 23_, the third number is a 6 or 0 maybe (hard to tell). The track itself seems fine, but the rollers on the right side have fallen off the drawer and the cabinet track. The left side is about to go too! The rollers look as if ... (cont.)