Viewing all customer Discussions for:

70-008 5 Pack, Screen Plunger Pin Latches, 7/32"

These are from a 2015 installation of All Ultrex (I believe now they are banded Marvin Integrity) single hung windows. The pins in some of the windows broke and some do not have the springs. I would like about 10 pins to replace broken ones and have on hand for future use.

Hi - I am trying to fix my screens which are missing a few plunger bolts and corners. The tops of many of the screens have bolts that seem to be the same as the plunger bolt but just inserted into the frame - no spring or plunger or hole on the bottom of the frame. Do you know anything about this ... (cont.)

Trying to locate this part that dates back to 2001 M&W windows. Would appreciate any help! Thank you, Dave

:looking for replacement screen plungers for my window screens

Installer on trimline windows claim can't get parts. Can you help

Your plunger pin 70-219 shows 7.32" diameter but the width of my screen is only 5/16" and the existing hole is only 1/8". Do you have a plunger pin that will fit this screen? Only one plunger pin is missing and the other pins are about 1 1/16" long, which means 3/4" of the pin is in the screen and ... (cont.)

Looking at your 7/32 dia 70-0008 window screen plungers. To repair screens from Hurd Windows made about 1993. large end 7/32 dia x 3/8 long small end 1/8 dia x 1-7/16 overall length spring .41 nominal or 3/8 plus prefer aluminum Qustions: 1. I assume these are suitable replacements. 2. Can I get ... (cont.)

I need 4 of these for my window screen. Plunger woth spring

I'm looking for a side pin for my full screen. The Windows are (Bonneville) which went out of business back in 2014. Do you have anything for this type of screen . Thanks

Metal with plastic tip

Hello,Truing to find a replacement for these. They are 3.5 inches long. There is spring missing from the one in the picture. Can you help?Thanks Frank

This is the original from the screen. It had a spring also that was stuck in the whole. No markings and Nu-life replacement part does not fit. Thank you for your help

Looking for replacements of the above pictures. These break often and looking for something of better quality and that I do not have to drill larger holes or modify the pre existing holes. These are not easy to get into the frame to hold because some are crooked looking for more sturdy plunger ... (cont.)

Trying to replace aluminum screen profiles. Everything sold now does not have retainer pins. Can I by these pins and drill the holes for pins?

Would you have the part identified in the photos attached

I ordered #70-219 they are to short These screen are off of MArvin Windows Can you figure out the correct part number? thanks Mike

Part No. 70-008 looks and sounds like a match for the broken plungers for our Caradco window screens. The frame of the screen is about 3/4" wide so the stem beyond the fat part of the plunger needs to be about 1" long. Looks like the handle just snaps on. Most of our problem is that the plastic g ... (cont.)

Hello, Please help me find the right screen insert pin. Picture is attached. Thank you, S

I need to buy replacement plunger pins for a screen part #A-X7164. Thanks

Plunger is approximately one and one eighth inch long. Cannot pull out of screen completely Please advise what to purchase Thanks PATTI