Viewing all customer Discussions for:

70-009 5 Pack, Screen Plunger Pin Latches, 5/32"

Total pin length 1 3/4 inches, Head to end of first shaft length 1/2 inch, remaining shaft length 3/4 inches. Head width 5/16 inch, bottom shaft dia. 1/8 inch, shaft diameter right below head 5/16th inch, I am missing a spring that should be on it. My screen storm trim is 3/4 inch by 5/16 inch. ... (cont.)

Several of my screens have lost these spring-pin screen locks due to wear and sun over the years. i am looking for replacement pins so that i may repair my screens. Thank for your help.

Hello, Attached are all pictures of parts for the screen window. Please let us know if you do sell this.

I am looking to replace the spring pins shown below.

Is the shaft that goes thru the screen frame on the 70-009 and 70-008 the same thickness with only the top being a different size. I don't know what the thickness of the top on my old pins are. If the shafts are the same thickness then as long as the hole the top goes into fits the top I think eithe ... (cont.)

I can not find the right pins. Do you have them? Here is a picture of them.

Can you help me identify this screen pin? I'd like a higher quality replacement if possible.

Hello. I am interested in your window screen plunger pins. If I ever need to replace the screen in the window, do I have to uninstall the pin? If I do need to uninstall the pin, how do I do that? Thank you.

I believe the numbers represent the parts we need. Our screens and windows were installed last fall. They are hunter green.

I need a bunch of the window screen spring loaded pins that hold the screens in. Are they available?

marvin window, screen window

Question for tension spring for screen. I have windows and screens that have tension bars with small pins attached to them that poke through the screen frame which then holds the screen into the window frame itself. These small pins have broken off the plastic tension bars on many windows. ... (cont.)

During the transition of mail personnel, our temporary mail person would place mail in the area between the screen and the decorative frame. Some days when returning from work there had been no mail or at least I thought. Some weeks later I received a letter stating that I had not cashed a check w ... (cont.)

I'd like to try to replace the broken plunger pins on my Marvin screen windows. Before I order them, do you have a guide to help me? I'll need about 100 plunger pins. Jerry

this is on the top of a screen it only goes through the frame to the spline track not all the way through

I have purchased the 70-219 plastic pins from SWISCO, and they are the perfect size; however, I'm wondering if the 70-009 pins would be better, as in they might not break as easily? Thanks for your help!

One of the pins that holds up the screen in my Forever Door has broken off. As a result, I am unable to lower the screen. I am also unable to raise the window because the screen is covering the mechanism that releases the window so that it could be raised. Is there a way to lower, or remove, the s ... (cont.)

Do you free hand the drilling or us a jig when drilling the hole for the plunger

I am looking for replacement plunger pins for our storm windows. They are in the form of a tee however. The plunger had a hole in the middle of it where the "handle" part come out. The house was built in the mid 80's. I don't know the brand. Do you have anything like that or know someone that d ... (cont.)

The pin/peg at the top of my peachtree window screen as seen in the first image has broken off several of my screens. I'm going to assume the best option is the plunger pin 70-009, but the frame on my screen isn't rectangular and I'm not sure if the plunger pin will work properly with my frame, see ... (cont.)