Viewing all customer Discussions for:

15-173 Pivot Shoe, 9/16" Thick

I need a window balance 30 inches

Downey Job- I will call

Need this to be replaced.

Hello, I recently ordered replacement 770 channel balances. Now I need to replace several shoes. The 2 shown are not an axact match - Hopefully upgrades. Can you please identify the part # I need?Thank you!

please help in identifying the part in the attached photos. i believe it is called a pivot shoe dimensions are 1" wide, 9/16 deep, 2" tall for a tilt window similar to your part number 15-045 but is deeper

I need a left and right set of these shoes.

do you have any pivot shoes that will work with what I have ? They are off of a Superior double hung window Thanks Andy

i need pivot shoes for a phillips window. the measurements are.1 inch wide,x1/2 thick x2 1/8 tall. the slot hole is 5/16. do you have any and if so what is part number

I am ordering S-600 balances x 29" with blue tip. The pivot shoe is approximately 1-15/16" high x 15/16" wide x 9/16" thick. Can you help identify?Thank You Bill

Hi Again, The windows we have were installed in 1990 and I believe the company no longer exists. Windsor? Windstrom?Something like that. Photo shows additional parts ( the shoe?) I may need but Im not seeing a match. It holds the balancer spiral as well as the shoe to the window. One of them is bar ... (cont.)

Hello, I have these old windows and would like to replace the balance mechanisms on the side but am having trouble finding the parts. Some of the windows won't stay open and some are just very difficult to open (feel stuck).

Need replacement part# for this shoe pivot.

I have a several windows will these balancers. There are a spring block and tackle type balancer with the a spring steel clip at the top. The outter pain is a 17” and the inner pain is a 19”Also need to identify the tilt blocks there are 1/2” thick 15/16” wide and 1 7/8&rdquo ... (cont.)

Balance is a thin spring in tube. If I can get a Constance force balance this size I would convert it to them. thanksSal

I need replacement parts for the above- the side rails/balances are either broken or rusted out....windows are hard to slide open/close and some cannot even open. Need new "feet" and the whole rail system. ???

I am looking to match several parts for my tilt windows with 3/8 spiral balance 1) pivot shoe lock 2) channel to covering the spiral 3) latch See below for pictures. Kindly help me identify which one would match in your product.

I need to order 10 of these please and thank you please help me figure out what they are.

Hello, again. I am the designated window repairman for our company; lucky me. As one of the included pictures indicates, I need a pivot shoe for a tilt window with spiral balances that is .5" thick AND 1" wide. It seems the thickness affects the locking of the tilt window pivot shoe. Can you fin ... (cont.)

I found a similar part 3/8" thick, but not 9/16" thick. Are they interchangeable? Is 9/16" available? Thanks. -Chris

1/2"thick. 15/16" wide.