Viewing all customer Discussions for:

82-008 Patio Sliding Door Handle, 6-5/8"

Att: Katherine Hi spoke to Katherine earlier today. This sliding patio door lock I have is just one of the two threads where the screws go in, is worn, hence loose. I don't see any brand name on the parts, except the marking '-1400 SERIES' stamped on the inside of the front and back plates. The ... (cont.)

I ordered sliding door handle set 82-002 after researching it on your site. The handle fits perfectly but when I install the unit sent, the hook is upside down, meaning the hook wants to go up into the catch from below rather than down into the catch from above. All the hooks of different sizes se ... (cont.)

We're trying to replace the door handles on our patio doors and can only find a replacement for the right side, your part #8200-8. We need a blank for the other door where they meet. The keeper in the first photo is not attached to the blank, so we shouldn't need to replace that. What suggestions do ... (cont.)

Assisting a friend. When she closes her sliding glass door from the outside, the locking hardware drops into the locked position; thus preventing her from accessing her house through the sliding door. She is locked outside. I dismantled the hardware. Printed on the inside hardware is the followi ... (cont.)

I need to replace switch lock, it went down the door frame

Can't find one home built in california 1971

I have two questions. I am looking at 82-002 to replace the broken lock on the patio door, but there are some differences. 1) Do you think it will fit? The measurements are perfect. 2) As you can see from the picture, the door handle/pull fits under the screws. Will I be able to attach the current ... (cont.)

Please I want to know which exact part I need to buy? Can you give me the link of your page to make my purchase? Thank you

I need the patio sliding door handle 82-008 and the latch 89-003 for my sliding door that closes to the right side. I found those.I also need the identical latch for the left side door. So the locking latch must be sticking out on the left side of the patio sliding door handle for the left side. I f ... (cont.)

From what I could see it looks as if your 82-008 model would work for my door, yes? I would also need a new lock too.

Looking through your posts, I see that I need 82-008 to replace the PR300, but looking at the attached picture, there is also the "dummy" lock on the left. Do you have something I can use to replace this?

Can the 82-008K directly replace an existing 82-008?

It's a patio door lock.

Holes: 6 5/8" center to center Door: 1 3/32" thick Mortise: 13/16" x 7 1/8" Bottom of Mortise to the center of latch slot: 2" I need a handle set with a full pull on both sides, not just a little ridge for your fingers.

I have a 6 5/8 center line to bolts glass sliding door latch . The latch is a unit that slides DOWN to lock NOT UP. Everything I can find locks moves up. This will not fit the hole in the door. The original in this discussion is the one I want to match up to. Thank You

I took this lock off my sliding glass door and cannot figure out how to put it back in. Please send illustrations.

Does door handle 88-002 fit with door mechanism 82-008? Thanks.

Please let me know which part # I need to order as replacement

Screw to screw is 6 5/8 inches as close as I can tell, Also, I have other doors with same latch assembly that I need to have replacement handles with brackets. Thank you.

I need the sliding 6 5/8" patio door handle replacement with a wood pull handle. I just see the metal piece, not the wood handle. Is that available? Thanks, Diane