Viewing all customer Discussions for:

19-018 Channel Balance Top, Pan Am

Hello,Please help me idnetify the part I need to order from you. I will need 4 balances to begin, for one double window.Thank you in advance,Jebran

The clips in the frame are plastic. Tried a newer balance rod but does not fit well in the channel. Top broke. The new ones had slimmer heads..

Looking for this part. Hope you can assist. 1975 aluminum windows. you have a similar part w/o the side wings measurem are h 3/4"w 11/16" d 9/16" wings width 1" there is a fight and left side part

Hi the length of the metal bit is 27". Do I need a balance of boith sizes? Thye window is 52" x 55". Thanks.

I believe this is a pan am 1820z channel balance. 18.5 inch. I also need the piece that fits on top of the window.

So, as you can see, two of these are rectangular 31-16 rods. No further information is discernible on them. The other is tubular and measures 25" without the tip, which measures an additional 1.625". It has no markings whatsoever. I need two of these tubular rods at this length, and two that are app ... (cont.)

I need to replace both balance springs and the guides afixed to top of windows also I will need two replacement Pan Am Take Out Clips. thanks for your help Tom

Good afternoon, can you please help me identify these channel balances and point me in the right direction? they are 18.5 inches long (not including plastic end pieces) and the only marking I can find reads "1840-" They appear to be just over 1/2" wide. Please let me know if you require any addition ... (cont.)

Attached are picture for what we need.Window Balances - Series 377 Non-Tilt18 1/2" LongStamp - 10 (window weight 9 lbs)We need 8 Balances and4 sets of top sash guide, Pan Am #18-042.Thank you,Francisca

Hi, I have two non-tilt channel balancers to replace with the following specification: 1/2" width 31" length (metal to metal) Sash weight 9 lbs The pulley side appears to have #15-005 winged channel balance shoe, 1" depth. However, I'm not sure what the spring anchor side plastic piece is. Hopeful ... (cont.)

I have an old 24" window balance with the stamp 23-3 on it. I do not see this part in your catalogue. is there an updated equivalent part? Thanks

Trying to identify the part, also I tried reinstalling but I can't get the window to fit with both springs reinstalled. Aluminum single hung windows probably from the late 80s early 90s. thanks

We need to buy replacements for these balance sashs. The code is 29-3 W. We also need to replace the clips to hold the new sash down. Could you please advise? Thank you!

23" Series 377 Channel Balance 2210. do the pictures I attached look like a match. thks Bill

I need two new ballances 30 inch since it is marked 2940I was having trouble figuring out the one I needed

I need the complete window balance

Hello, Trying to find replacement rods for a window that weighs approximately 14lbs

30 inch metal length1/2 wide29-3-W stamped on metalApproximately 32 years old

GOOD MORNING,I HAVE SENT SEVERAL PICTURES OF 2740 BALANCE ROD & CLIP NEEDED TO REPLACE 8 OF EACH IN ALUMINUM WINDOW.LET ME KNOW IF YOU CAN MATCH UP CLOSE ENOUGH TO WORK OR IF YOU HAVE THEM.THANKSRENEE

Please identify the balance channel attached. I was unable to take photos of them installed. Balance channel is 1/2"width by 28" long. Special marking is 2740. let me know if you need anything else.