Viewing all customer Discussions for:

21-002 Bifold Door Pivot Pin, Benchmark

Need to find floor track and top pin for 3 bifold doors

Both bi-fold doors in the picture get stuck due to a worn and dented track. I'd like to replace the top and bottom tracks. It's 48" wide. I'm just wondering if the tracks you sell are compatible with these doors. Also, the doors don't close flat because the 3 existing hinges are rusty and have ... (cont.)

I have no experience with this kind of door but I am handy and have been doing some research. I'm pretty sure I can figure it out with the correct parts. I have many more pictures if you need clarity , including pictures of a working door with parts intact. These doors have been a nightmare but my ... (cont.)

Dear Support Team at Swico. If you can please help me identify the elements needed. I would like to replace the following hardware for some old metal bifold doors. I would need the bottom and top pins. I also need to stopper in the middle and would like to replace the old floor aluminum rack (extre ... (cont.)

Plastic sliders compromised, do not hold on to Inside pins where the two doors close.

1977 home

Looking for replacement hardware and diagrams for 1960s steel bifold closet doors

5 1/2 inch on the guide pins, 5/16 thick metal 3/8 thick plastic sleeve 6 inch long pivot pin. 3/8 thick plastic collar and 1/4 inch thick metal pin

I think I've identified the parts I need. They are: 1. the stopper with the screw that prevents the top axis pin from sliding. 2. The two plastic rollers that go on the top sliding pin. The width of the track sliding slot is 04" or 10.3 mm The diameter of the top sliding pin is 0.18" or 4.6mm My on ... (cont.)

I need help finding a 60-in and a 48-in track that would work for these doors. I have. The current tracks look like the photos I submitted. Thanks Patrick

Hello I'm just having a bit of trouble finding out what parts were used on this bifold door working on it for a home owner they didn't know how long ago it was on there Hope you guys can help me out if you even still make these parts or have something similar to them Thank you

I would like to replace both tracks on this 48" steel bifold door as well as all necessary hardware.

Have a lot of pins and grommets needed to fix 10 closet doors

The doors are marked "Benchmark Bi-Fold Steel doors" and each set of doors is approximately 48" wide. I would need the top track and bottom pivot/track- the only thing I have is the doors.

I am looking to replace all the mounting hardware for my 96-inch bifold doors 1975ish (full-vu. Model 8433 Serial 861097 I just want to make sure I get all the correct parts or any missing parts. If any kits work, I have no problem replacing the tracks. Thank you Paul

Hi I need to replace hardware in all 6 doors. Please help to identify what i need Thank you so much

I am needing hardware for a project that we are working on. They are metal louvered bifold doors. Needtop and bottom hardware for 1 set. I have attached pictures of each. I estimate the home to be built in the 1920's but not sure when the doors were added, possibly original. Any and all help would b ... (cont.)

I have a few sets of bifolding doors that I need lower replacement parts for. The current parts and door photo are included.

Wondering if you have these exact parts?

Hi, We are looking to replace hardware for our metal mirrored bifold closet door 3' opening. Attached is a photo of some of the hardware pin & slide. The door has to tracks top & bottom and was installed in the 1980's. Thank you. Rodger & Ivy