Viewing all customer Discussions for:

21-054 Bifold Door Top Pivot and Guide Pin, Leigh

I need pin caps for sets of Leigh Full-Vu steel bi-fold doors. The part number on the door label is 6956. I need both upper and lower caps for 20 doors. I would like to send pictures but can't figure out how to send to an internet address. Can you help me with these? Thanks, Jim

my pins or the ones i am looking for are about 5.25 long with a .250 shaft with a groove for a hair pin clip and the cap on the top is about .410

I am looking for a metal bifold door track. see pictures below

I have been looking for a replacement plastic knob that fits on the end of the metal pin into the floor track of these metal bifold doors. It is actually the white piece in the pictures. I need one of those for a different closet door that is of the same style and make. I could not find any markings ... (cont.)

Hi We are looking for the spring part oat the top of the Full Vu closet door in the attached pictures. In goes from the top of the door into the sliding track. Thank you

The top guide wheel is not able to stay up seem to be missing an nylinder and bottom guide wheel is Bent Ned a replacement part Steel Full-Vu Door Leigh Products, Inc.

I am trying to fine the correct pins for a Flow Away ,steel ,mirrored ,bi fold closet door. The doors have two different types of pin holders. Most of the doors that work have white plastic bushings at the top an bottom of the steel door with some kind of black plastic for adjusting. These seem f ... (cont.)

Hi there. Looking for a replacement of the bottom pin on the old bifold metal door. What I know is that it is 5.5 in long and 1/4 in diameter. This is the original door that was installed by the builder sometime in early 60th. Any suggestions you can provide on the type of the pin to use would be gr ... (cont.)

Hello, I need part numbers for both complete pins and brackets for bi fold doors as shown.

I need to replace the track to my closet door. Attached are photos of the track that needs replacing along with the pins. The pins seem in good condition but the caps need replacing and maybe the springs. Can you please recommend replacements for these parts? Thank you.

I have 8 of these bifold doors and on some of them, the upper and lower pins need sliders. RIght now the pins have no slider guides and are metal on metal. Attached are a few pictures of what the good sliders look like (upper and lower)and a shot or two of where the guides are missing. I am in need ... (cont.)

I have Full Vu folding doors Leigh with a stamp on the inside that says Leigh Prod 5702-2. I think they are bottom pivot. Looking at your catalog it looks like I need six of the 21-054 and two of the 21-048 or two of 21-051. What do you think?