Viewing all customer Discussions for:

21-200 Pivot bracket

Hi, Please help me to identify the right pin cap. My pin diameter is 10/32". The bottom diameter of the cap is 12/32" and the length of the cap is 12/32".Please see 3 images attached.From your website I bought pin cap part # 21-100 which has a internal diameter is 1/4" and thought somehow I will be ... (cont.)

4 doors that are 18" each for 6' total closet opening I need the plastic tips on the pins (note that the threaded pin has a smaller dia than the other 3 pins where the tip is installed). I also need the track for the top and the mounting brackets (or track) for the bottom of the door and any addit ... (cont.)

Looking for replacement parts for my doors.

What do I need to make this bi-fold door work smoothly?It scrapes and is difficult to open and close.Thank you very much.MikeI will send pictures of track also. Perhaps that needs replacing too.

I need the hardware to get the door back on it's track. I want all the parts replaced and instructions on how to install it

I need the piece that hold the door shut on top rail

Do you have replacement parts for these doorstep? If so, What are your part numbers for the parts shown on these doors?

Nylon missing on guidance track pin. Door catches unexpectedly while closing/opening

Hi. Bought the home . No clue of manufacturer or when they were put in. No one seems to know 1. How to replace or 2. Where to get the parts. Gosh, I hope you can help! There are a bunch of these in the house so I assume will happen again. (The top one had a plastic cap.) Pix below. Thank you for you ... (cont.)

Hello, I am looking for this piece for 1993 bi-doors. Can anyone help me? Thank you.

Bottom connector to the guide in the floor. The top of the long rod has a slot to adjust the height of the door with a straight screw driver. No manufacturer's name o Rd number is available. The door is about 26 years old.

We have a mirrored slimfold model E door going into a small walk-in closet. The bottom inside pin constantly shifts in toward the closet edge, making it nearly impossible to get the door opened or closed. Not sure what parts we need. Am reasonably sure we need new bottom pivot pin and possibly ... (cont.)

Hi, I need replacement pins for some old Slimfold Model E closet doors (see pictures). I think I'm supposed to have three retractable and one stationary, right? I sent pics of one of the two doors. What do you think? Thanks!

Good day. Glad I found your site. I need to replace the 4 pins on each door because the old ones have worn out or broke. The plastic pin holders fall out or are broken. When I tried to reinstall with the old parts it was difficult to place properly. One of the top holders will only move a little way ... (cont.)

I need two tracks 10 feet long for the ceiling and two tracks 10 feet long for the floor And 22 pivot lock One 3 feet ceiling track & One 3 feet floor track

I need replacement parts for Slimfold BiFold Louvre doors. Please review the picture of the parts and advise regarding which replacement would best suit my needs. Many thanks. Regards, Louise

I have bifold doors that are badly in need of replacement parts. The doors do not stay on the track and are very difficult to open and close. I have attached pictures of the doors with the hardware exposed. These are model E doors.

WOuld you be able to supply parts for these doors.

Hello, I have a slimfold bifold mirror door manufactured by Dunbarton. However they do not ship to my area (BC, Canada). I need the aluminum track and bottomless bracket hardware set. I put someone else's email address because it wouldn't accept mine

I am looking for replacement part for some Weldwood bifold doors (they are metal not wood doors) specifically the pins and any related hardware which holds them in place.