Viewing all customer Discussions for:

33-077 Double Groove Pin

No part numbers.

Hi, my 70s era crank out is broken. Please confirm that I need to replace the mechanism. It's right side crank. Do I need 5 1/4"? Let me know if you need anything else.Joy

Hi - I am redoing an old house and have purchased 22 of the 39-346 replacement handles. I am missing some of the smaller e clips and double grove pins (picture attached) that go with the 39-346 set. I would like 4 of each if that is possible? In addition I am repairing old larger windows that use a ... (cont.)

Need 2 1960 7/16"spline aluminum awning window crank handles. Do you sell these.

Hello, the part I need the piece that holds the control arm to be cranked out. It has no threads and is held in with a clip. Please let me know if you need any other measurements or descriptions. Thank you

Sorry, not too techy.

Good morning, I am searching for a few parts on a glass window that are in sections or panes. I am including some pictures, one is a plastic piece that allows on glass section to move up and down. The other is a pin that connects the window to the regulator. Lemuel

Stanley part # 10-8231-RH two screws on top and bottom 5.25" apart. The gear pivot came loose but I don't have room to press it back in. Looks like I need replace. Do you have this part and can you direct me to installation video? Thanks

The crank handle has disengaged from the lever controlling the opening louvers. It looks like pin has sheared off. Also plastic clips have become brittle and broken off. Rubber seals have hardened and become ineffective. Basically a renovation job which I can do is now in order as long as I get the ... (cont.)

Your part: RH Window Crank Operator, 3/8" Hole Product Code: 39-194 Looks like a match, but the old one has a C-clip on the operator's arm where it connects to the torque arm. Any thoughts?

overall length 5-3/4" mounting holes 5-1/4" width 1-7/8" mounting holes 1-1/8" arm length 3-3/8" arm width 5/8" hole dia 3/8" made of steel

recently I purchased from you part number 39?017, the Pan Am/ Daryl window crank. My window is 83 years old, and unfortunately the arm of the crank is not held on with a nut and bolt, but with the mechanism that I have included in the attached pictures. I have scoured the Internet and cannot find ... (cont.)

These window supports are available it is the pin that it attaches to is the problem. As you can see in the picture, the pin falls out clip still attached. Any ideas on how this could be reconnected? Some of them are gone, maybe could be fixed with a screw? Any help would be appreciated.Thanks,Terry ... (cont.)

How does the arm of the crank attach to the hole in the arm of the window? Is it a threaded bushing with a screw?

Good

Hi, I do not know what the part is called but it is a half-moon pin joining the arm that opens when cranked. I am looking for that pin/moon part. Thank you

I can't identify the brand of jalousie windows. I need the rivets, rivet casing/washer and clips for (a) connecting elbow parts together and (b) connecting the parts to the side wall track. (ie. I've already purchased a couple of new crank boxes, but the rivets I bought to connect them to the re ... (cont.)

Looking for these parts for old crank swing windows

What hardware is needed for this operator. There is nothing at the attachment point from the operator to the mechanism that opens and closes the window. How does one know what's needed? Both windows are minus operators and hardware to the mechanism. POW AWNING OPERATOR Product Code: 39-183 Tha ... (cont.)

No manufacturers identification on handle. 5/14" center of top hole to center of bottom.