Viewing all customer Discussions for:

39-529 Truth Hardware Track Slider

I'm needing help identifying the window cranks in the images I'm looking specifically for the window crank mechanism operator. The teeth have been worn down so the crank doesn't pull the window completely closed.

I have a 39–258 and a 39–259 handle operators in my cart but need these clips to go with them. Do you sell them?

Vantage I Casement window 287-N-022 When opened more than a few cranks, the push arm falls out of the little plastic slider, and the window will not open or close until the arm is manually re-inserted into the slider. The installed picture is looking up at the bottom of the partially opened window, ... (cont.)

Weather shield handle. Two arms. 4 screw hole on either side. The long arm is about 10", the jointed, most distal arm is 4 7/8". It says 093099 11:27 on the back.

Don't know how to order so it's the right one

Truth operator dual arm operator Long arm has number 41011 stamped on it Short arm has number 31876 stamped on it I would need both left and right hand units.

410012 is listed on longer arm Shorter arm is 4 - 7/16 Black slider piece is broken I believe it is right handed

Hi, I am looking for replacement parts for this window. I believe this is an assa abloy, interlock part as it says interlock on it. Let me know if you can point me in the right direction please. I'm looking for operator, cover (if I can't reuse the existing), track, and hinges and any other parts I ... (cont.)

Trying to match up this crank from back in 2001. Looks a lot like you 39-253LB except my white cover is affixed and does not come off. Original manufacturer was Truth Hardware #31876 stamped on bottom of one of the arms

Hi, Do you have the casement hardware like the one in the picture?Could you please let us know what additional information you need from us to identify it and provide a quote?”

I think the gear mechanism for this opener jammed or got out of alignment. It was stuck in the open position so I had to remove the hardware to pull the window closed. The sticker in the picture is the only legible identification that I could find on the window. I think I need the whole gear mech ... (cont.)

Photos of in place piece. Arm has a plastic piece on a knob that broke so arm will not engage slide on window bottom track.

We have five windows that need cranks replaced. If parts are available and what cost would be. Thanks William

Not sure what this part is called

hi there I am looking to replace this hardware.

I believe this is a CertainTeed window. Window cranks out but not back in. The operator linkage is stamped Truth. Dimensions are as follows. Long arm is 10" Med arm is 7" Curved arm is 4.75" Hidden arm under window is 4.75" Left & right side operators needed. Thanks for your help. ... (cont.)

I am looking for 2 window crank mechanisms for my Milgard casement windows built in 2000.Can you help me out?Bob

I need to find a replacement for this operator. The window is manufactured by Milgard. I do not see a way to separate the cover.

Hi. Looking to identify this operator to order the correct part. I also need to know if the cover comes off and how.