Viewing all customer Discussions for:

26-360 Tilt Sash Pivot Bar, 2-1/2"

I would like to buy some replacements

Last year I purchased a pair of your balances after sending a photo. I just got around to installing and the (existing) rod that rests in the metal part of the balance doesn't fit. You can see from the photos there's a ridge on the old rod and the required part should be just a rectangle without the ... (cont.)

Attached pic shows my broken bar beside two samples. Sample 26-398 at bottom of pic hole placement would work but it flares at end end. The 26-360 is flat but the hole placement us wrong. Anything else that might match better? Thanks

i need 20 450 alum sh parts pivot bars, drop-in vunyl fin ins... do you carry these

I am finishing a job someone else started. They have already purchased the 15-129 pivot shoe. However, I need to replace the pivot bars as well. My question: will the 26-316 pivot bar work with the 15-129 pivot shoe? Thanks - Donald

I need several pivot bars replacements for my crystal windows. I've attached the pictures... the bar measures 2 1/2 inches long

The balance is 28" long and 3/8 diameter The plastic pivot shoe is 7/8 wide and 1/2inch thick and inside diameter is 3/4 inch I have five vinyl clad windows and need 5 sets. One lumber supply company thinks these are Croft windows. The track home was build in 2003.

Balance spring with indent at bottom (28 bis), window pivot bar, and window brake. Do you have parts I could use?

Please help me find shoes.

Attached is a picture of a pivot pin i need from an unknown window manufacturer. can you help?

I need Parts for M&W windows is pivot shoe 15-118 a match? Mine has the numbers 5900SB on it and a blue center piece I also need balances, locks, pivot bars and tilt latches I have more photos and measurements if needed. Thank you Greg

My windows are less than a year old and two pivot bars on the bottom of one window broke. I can't get hold of the installer so do not know the make of the windows. I took the broken bars out and the number #23111 is on the bar. There is also a 6 on one and a 4 on the other. When I did a search on yo ... (cont.)

We need about 8-12 pivot bars for our slider windows...the overall dimension is 2 1/2", the screw whole placement is at 1 3/8" & 2". There are two barb like bars comming out of the right & left side 7/16" down from the main rotating bars. Bars have 4 circles stamped into the bars in between the scre ... (cont.)

The Pivot Bars I need look almost identical to your Product Code 26-360 except that they are 2-15/32" in length and have two holes centered 1" apart with the first hole located 1-7/16" from the head (opposite the pointed side). I do not know the name brand of the window though I think it was a milg ... (cont.)

ineed this parts for window

3.5" total length 7/16 width on end, 5/16 width on shaft. Holes 2 1/2 and 2 15/16 from end. Please see photo

Could you post more pictures of the 20-360 tilt bar? The picture is confusing and I need to see the T bar area more close and clear for replacement. Thanks.

Looking for a pivot bar that looks like this. Unsure of window manufactorer? This is 2 1/2" long. Anything here that would fill the void of this pivot bar? 636