Viewing all customer Discussions for:

33-207 Shoulder Bolt Bushing

Missing female for part 33-067. Ordered part 39-074, 33-067 but I need the female for the screw of part 33-067. Can you help?

There are no markings at all on the crank assembly. It came off a Jalousie type window. Any help would be appreciated. If you have them, I would buy them from you. I need around 8 or 9. They are for my sons sun room windows off the back of his house.

Please let me know what other photo angles or information I can provide.Measurements:casing: 150mm X 50mm X 25mmtwo hole base: 59mm X 22 mm, screw holes 7mmswivel arm: 69mm X 15mm, hole diameter 12mm.

Part for an old jealousy/awning window

Hi! I recently bought a house built in 1969 and I think the crank may be original. It is a Pan Am and it might be 6007 for numbers on it. The crank part does not close the window now and I'm trying to replacing the entire crank so that I can operate the window. It is a right side window crank.I obta ... (cont.)

I need 1/4"-28 shoulder bolts and plastic bushings for Woodco window crank arms.

I, too, have LEMCO Series 30 awning windows. I am looking for the LEFT HAND crank.

I need to know the correct replacement part ro order.

Hi, I have awning windows that are stamped/branded Pan Am, I uploaded a few pictures of the cranks that they used could you look at the picks and advise what type of replacements you have that could be used?

Good afternoon, I'm looking for two left hand crank assemblies to replace the type shown in the attached photos and drawing. I can send more if needed. Windows are circa 1979, all aluminum.

I've been searching for a replacement window operator like the one shown in the attached photos. No luck. There are no names or numbers on the operator or window frame. I can probably mount an operator that doesn't have the lower dogleg and can transfer the old connecting link to a new operator ... (cont.)

Can you help me identify the parts in the enclosed attachment? I will,need 3 of them and also need to return some incorrect parts I already ordered and received. Thank you. Chris N

Can you please help me identify a replacement for this part ?

Hello, I recently bought a 39-074 : Lenahan Window Crank. How does the arm of the crank fasten to the awning. I bought 33-067 and 33-207 but I don't know how they go together or what the threads on the 3/8 shoulder screw screw into. The arm on my awning just has a hole. The same as the hole in ... (cont.)

I need 2 that goes to a window in a bedroom.

Hi, I recently received a panam/Daryl window crank 39/017 there is very little difference between the old crank and the new crank, except for where it attaches, the screw and the rivet. What hardware do I need? Thanks and have a great day! Lynn C

I need to find the clear plastic connectors (bushings?)to be able to connect the crank with the window levers. If it matters the crank is 4 1/2".

The housing part of this is 4 7/16" vertically and 2" horizontally and 3/4" thick The mounting screws at the top are10/16" apart from center to center The mounting screws at the bottom are 1 1/2 " apart Below are pictures of it from many angles including one where it was still mounted on the ... (cont.)

I wrote on your youtube for awning window winder and your website here asking for help and sending you pictures since not hearing from you bought Barton Kramer at Ace it fits as a replacement for the damaged stripped unit i had in my 1969 Condo in Miami Beach but never heard back from you since your ... (cont.)

The part only had Daryl Miami fla the building was built in 1974. Thanks for any help you can offer.