Viewing all customer Discussions for:

81-153 Tandem Sliding Glass Door Roller, 1-1/2" Concave

1 1/2 inches high 3 1/8 inches long 11/16 inches wide Wheels 1 3/8 There are 2 metal wheels

I need a replacement top guide, similar to your part 86-025 but mine is only 7/8" wide that must slide into the frame. Im also looking for better rollers, I have 1 1/2" PLPCI.net D 1822 rollers, look like your 81-261 product but they are so noisy Is there a replacement that has poly wheels? I nee ... (cont.)

Jack Lewis - need 2 replacement pieces for the photos attached and 2 mounting screws to go with the parts. Dimensional info as in photo: Wheel Dia. 1-1/2" Length is: 3-1/8"Height is: 1-9/16"Respectfully,Jack

What is the width dimension on this unit. Do you have a roller assembly that is not quite as wide as this one? We just took one out that appears to be exactly like this one in configuration, but it came out so hard I doubt if we could get one back in there

Please give the height (not including the wheel), width and length of parts 81-083, 81-093, 81-056, 81-153, 81-155 and 81-095. Thanks! I need new rollers but without this information I can't figure out which of these will fit my door!

Require new replacement roller assembly for Glass Slider Patio Door.Door has "ESP of FLA" on Frame,Jam.Have found your Product # 81-153 in catalogue.Please confirm this is correct replacement.Thank you in advance.John

My local repair shop quoted me a replacement with a tandem wheel. My door has a single wheel. I ordered 81-093 which appears to be a virtually identical part and should slide in nicely. From what I can tell, there is plenty of room to slide a longer housing in, like one that would use a tandem wheel ... (cont.)

Hello, can you match this part ? House built 2002 original rollers, Palm Coast Florida, thank you,Jim. Sorry no measurements, just pic's.

Their is a number on the side 041/1

Would like to see a match for this part.

Hello I'm trying to find the roller wheel is for a outdoor sliding door I provide a picture of the ones I have get back to me ASAP thank you for your time

We need new rollers please and thank you

Hi, I have a dual roller for a Kinco insulated door. It's stamped DISCO 2191 and it replaced the original roller once before. I am sure that your best match is the 81-153, the question is my 3 1/8x 11/16 part is pinched-in where the press fit pin through the wheels assembly attaches to the mounting ... (cont.)

1.5 h x 3 long x 3/4 w

Sliding door roller...GACO 4140H

New post. I found part 81-153. Does this look correct? Thanks

1 1/2 concave roller 3/4 wide housing 7/8 flare 2.0 long 1 9/16 tall 1/4 20 screw at end above adjustment screw adjustment screw bottom of end of part Two questions Can I switch to a tandem roller? Repair house suggested upgrade to tandem. Can I get Nylon rollers to help with d

These came out looking for replacement with Teflon wheels. Heavy hurricane door

I am looking for these in nylon

Please see attached photos. I believe this is a florida extruder International (millstone) sliding patio door. It is 6 feet by 8 feet and IMPACT GLASS. I need to replace all of the rollers. Can you please provide me with the model number of the door and the roller model numbers that I ne ... (cont.)