Viewing all customer Discussions for:

S385-27 27" Series 385 Channel Balance

I'm needing two replacement balances for the part listed in the pictures. The numbers are it are included in the picture (2640 BSI PP) I have purchased balances from you in the past for larger windows. Thanks!

Milgard sliding window, single hung, channel guides are broken.

Left side of my window sash dropped it is stamped on the back 26 3 JN Caldwell. do you have this part and do I need to replaced both sides ?

Hello, I'm looking to replace a balancer rod that is broken. I included the stamp that is on it. Do you carry this particular one? If additional photos are needed, I am happy to provide them. Also, does it make sense to replace both if only one is broken? Thanks! Beth

the rope is broken!

I need to order new balancer's For my windows. I also need to order the piece that holds the balancer to the window.

Hello, I need help identifying the attached balance channel. I need a qty of (10). Thank you,

Hello, I would like to purchase new window balances for my windows. I was told that they are 27" balancers but I dont know what exact balancers I need to purchase. Hopefully the pictures provide clarity regarding this and I appreciate any direction that you can give. Thank you for your help. ... (cont.)

I need two window balance with this P/n

Hi I'm trying to locate the proper window balancers for my windows The old plastic pulleys inside the channel are broken and the string on another broke.

25.5inches markings:25 3 190 RN 27 inches markings 2640 TS2

Hi, Do you carry the balances pictured here and if so, could you tell me the part #s and prices? I also need new ones for some smaller windows but I've reached the photo attachment limit so will try to send those in a 2nd message. The smaller windows are about 19.5" long and the longer ones are abou ... (cont.)

No markings. 27" long (metal only) Just over 1/2"deep Just over 1/2"wide Photos of end pieces provided

I require 3 different balancer types so due to the restriction of five photo uploads I will send three separate messages numbered #1, #2, and #3. The windows are 21 years old and while only a half dozen of the balancers have completely failed, the others are very stiff so my plan would be to replac ... (cont.)

I need a block and tackle window balance, quantity 2, to replace broken ones for my non-tilt double pane window. Stamping on the balance is "26 4 GS CALDWELL". The metal part measures 27". Pictures above. Can you quote me replacements.Thanks,James

I have non-tilt windows. The width of the channel balance is 1/2 inch. I have some 28" in length stamped B.S.I. 2730 and some 24" in lenght stamped B.S.I. 2330. See photos attached.

I need 6 of the 27" and 2 of the 23" there was no markings and I measured just the length of the metal. They did measure 9/16 which is your 1/2 ".

Channel is 27" long by 1/2" wide. Marking is "26 5 AX CMC 1"

Metal channel not including plastic end measures 27 inches. 9/16 wide.

Can you help me order the correct balances for two different windows? I have identified the two as SM and LG. I have additional photos, but I was limited to 5 photos.