Viewing all customer Discussions for:

S385-27 27" Series 385 Channel Balance

The spare measures approximately 27"on the length ( metal front)

27 inch channel. The numbers printed on the unit is blurry.(See photo) What's missing is a clip that holds the channel.(see photo of the clip from the other side)

Measurements 27 inNo markingsWindow sash weighs 22 lb

27" channel, Writting: 2640 BSI (followed bt small "FB")

Channel Balances Markings on metal: 26 5 CMC Metal part is 27" long I can send photos if needed. Thank you in advance,

What is the right part to order as a replacement for this part?

Not exactly sure which replacement part # to order. The side is stamped Caldwell 26-4 GM . Window weighs 19lbs Thanks for your help.

How much to buy and ship the following:26-4 FM5 CMC 8Those are the numbers that are stamped on the side of the balancePlease assist. Thank youDavid

Hi , I need to identify and order a replacement channel balance. I have attached photos, markings and length as outlined. The length of the channel balance is 27" Thank you John

the width is 1/2" and the length is 27" . The numbers on the body are : 2640.

Window balance 26 3 B61 VN

I'm seeking replacements for my 26-5 DQ Caldwell Balances. The metal channel is 27 inches. The width of the bottom end plastic piece is 1 3/32"What would be the correct replacement parts?Let me know if you need any additional informationThank you!!Steve

Channel length 27" Stamp = 26 4 GE CMC 11 Manufacturer = MW 2 balances for one window, left side and right side

Strings broke on these balances, need 2 replacements. Stamped on the balances: 26 5 IU CMC 2

We have several windows, actually all of them that need replacement ballasts. All windows are the same size and should have same springs. I will verify once we get a part number. Thank you for the help.

Numbers on my channel balance are 26-3 kx cmc 11 The metal part of channel balance measures 27inches. I need 2 replacement parts. I will also need 4 new takeout clips to go with these parts.

Hello,I recently ordered some sash guides 18-171 Stepped Sash Guide, Alpine. They fit my current balances and matched my old ones perfectly. Unfortunately, they didn't fix the problem of the balances shooting up out of place. We have a manufactured home built in 2005. The balances look ok, but they ... (cont.)

Hi. I need replacement block and tackle channel window balances for my side load sash, single hung window. The string broke so I think it makes sense to replace the entire channel balance instead of replacing some of the internal parts. Hopefully you can tell from my images, but what part do I need? ... (cont.)

Hello, I have 3 windows were 1 of the 2 channel balancers broke. I am looking to replace them but having a hard time matching them to find the right replacements. Two are on the same sized window but one is on a thinner but taller window. All three are identical top and bottom with the same 'hoo ... (cont.)

Need a channel balance stamped 26050 FU CMC 2 for a Millguard single hung open up no tilt.