Viewing all customer Discussions for:

S385-30 30" Series 385 Channel Balance

Part # 2330. 24'' long I need 2 pieces Part# 2930. 30" long I need 2pieces. the plastic ends are the same as part # 2330 Photo included

I have Nuair windows. My home was built in 2005. The balance lengths measure 30" (metal to metal), 1/2" wide and are stamped with this number 29-2 KX CMC 7. Is this enough info for you to determine what replacements I need?

I believe my windows were made by Kinco. House built in 2003. Actual metal length of balance is 30".

Channel length 30 (thirty) inchesStamp printed 2930BSIdo not know who manufactured but it was installed 19 years agoneed quantity of 2 Thanks for your help!! From Diane

These are the balancers I have and I would need 4 of them. It looks like I need the 30 inch S380 in stamp option 29-9.

30 inches long, 1/2 in wide Stamped with "29 3 ET CMC 4"

Pictured are guides for 2 different size windows 2nd marking is 2990 hard to see in picture should I just replace both sides on each at the same time?

Several windows of different size have rusted out on the bottoms. Included are photos one of the windows hardware.

Metal part (excluding plastic) is 30" x 5/8". 29 9 HW CMC 7 is printed on part. Sash weighs 29 pounds.

The balance is 1/2" x 30". The writing on the metal is as follows: DB102 2920. Also need is end cap for the window at the top - Picture enclosed

Hello, I have 7 Nu Air windows, all with the same ~60.5" height, four with a 51" width, two with a 35.5" width and one with a 34.5". They pretty much all have an issue with the locks not being able to close cleanly or not at all. The wider windows have two locks and only one will lock on each. I t ... (cont.)

I would like to order 2 pieces of windows balances

I need to know what model to order for this channel balance. It measures 30". I would need two since both are not working. Thanks for the help.

I need 22 of these. I think it is the 30" series 385 channel Balance. S385-30. However I measured the winged channel balance shoe depth and it is 1 inch. Not 1-3/32 as this one is showing on the website.

Hello. Can you please let me know which balancer I need for my Milgard single hung window? The numbers stamped on the balancer: 29 5 FX CMC 7. Thank you for your time.

The silver metal arm is 30". Single pane windows that were the original windows from the home builder. I have 2 broken windows, both which need the left arm balance.

Could you help me identify these. I need 2 of them. Thank you

The above is the writing that appears on the side of my broken ballast.

Please identify this part, and let me know cost per piece. Markings on piece: 29 5 JT CMC 2 Thank you, Chris

Need 5 replacement channel balances, take out clips and product 19-002