Viewing all customer Discussions for:

S385-30 30" Series 385 Channel Balance

Channel is 30" long, Stamp is: #2950, Norandex manufactured around 2004, quantity of 1 each.

I have two windows which popped a sash guide (probably dried out) and the balances are extremely difficult to move. I think I located the guides as the 5/8 Norandex variety, but I need to make sure I'm picking up the correct balances. The only thing on the side of the balance is the stamp "2930", ... (cont.)

1/2" channel, 30" long. 1-1/8" deep lower piece.

Balance stamped It is 2950 BSI -Lenght- 29-14/16". Balance stamped 35 DS 35-Lnght is 36"

Hello,These are the first 5 of 11 pictures. 9 pictures are of one window. 2 pictures are of another window. I believe the windows are Kinco, series Mark 40/50.Please let me now what Balance to purchase.Thanks,Tom

1/2" width 30" long Only identifable numbers are 29 4 BSI Out of frame, with spirng in resting position, spring is approximately 18.5" long Windows are non-tilt, roughy 33.5" x 33.5" square

Hello, I am replacing my clips and window balances for my single-hung window. I just wanted to ensure I was getting the correct parts before I purchased it. I have attached pictures of my clips and balance. I think the replacement part for my window balance is part number S351 and the top clip is P ... (cont.)

My chanel balance it's 9/16 , I wonder if this part is the right one .

I have a 30" window balancer that is stamped with 2990. I can't seem to find anything with that matches.

Hello my window need new channel balance please see attached pictures. The channel length is 29’

I am looking for a replacement window balance (x2).The length of the channel is 30inches and there isn't any stamp/number on the original.

Please let me know the exact channel and channel guide i need to order for this window.

Need to find replacement for this channel balance. Part 29-3 ga2 cmc 24. Bottom Guide: Guide I have is one 1” and winged Top Guide: Guide seems to measure 1 and 1/8” and winged

I need help. I need to purchase 4 of these. Can you recommend me what to purchase. The only markings I found is: 29 2 BSI TJ

I have the need for two ballast - This ballast is stamped 2930 - 30 inches in length without the end boots. I would like to order at least two of them with the boots , boot width is 1 3/32 in width. Would also like to order a bag of the end caps for the window. Can you help - I have ordered from in ... (cont.)

I need 2 pieces

The balance is 30 inches (metal only) long, 9/16 inches wide. The attached pictures show the ends of the balance.

Stamped 29 3 JV Cmc 2 and 29 3 GV 2 A little over a half inch wide

I need to identify the two channel balances and 2 window sash parts in the included photos so they can be replaced.

Good evening. Most of our windows will not stay up anymore. I have taken this window spring out but do not see any kind of markings on it at all. It seems to be 1/2 inch wide and 30 inches long. I would just like to make sure I get the right ones ordered up. Thank you for your help ... (cont.)