Viewing all customer Discussions for:

S385-34 34" Series 385 Channel Balance

Width - 1/2" Length - 33.5" Number of parts needed - 4

I am Berge. I need 2 side balance springs for Jeld Wen window stamped 3340. also, 2 sash cam or sash guides, as pictured. Please identify and let me know if you need more info, otherwise advise me which parts to order.I have ordered from you before.

Could you please let me know if you can help me identify the replacement for this balancer? Thank you!

I am looking for this replacement. I need two of this item. It is for a non tilt window. House was build in 2002. Thank you.

Hello, I need to replace the window balances in a customer window. Attached are some pics. What is throwing me off is the fact that the length of the balance is 34" but the part number starts with a 33. Thanks, Chris

I have the balance out but cant seem to identify what sizing or weight rating it is and i need to know so i dont order the wrong parts

Need some new balances,I think these are S380-34??

See images.

Hi. I'm trying to replace channel balances of two different sizes.One of them is stamped '33 4 B.S.I.' and the other one is '27 4 B.S.I.'The balance shoes look like S380.Please, help me find the right parts.Keith

The balancers have the number 3330 written on the side, and the letters "LM" with now other markings. I measured the metal-to-metal length to be 34". The channel is 5/8" deep and approximately 0.584" wide. There are broken plastic pieces attached the top pf the window inside the channel that stop th ... (cont.)

Need help finding the right channel balance

Could you please advise on the correct replacement part for above window balencer. Its about 20 years old Thank you

Length is 34 inches; Stamp 3330 BS1 NN (see photo); Unknown manufacturer, installed around 2001; Two balances are needed

Please help with the channel balance selection.Thank you,Louie

Stamped with "33 3 IO CALDWELL" measures 34" long by 5/8" (1" including end fittings)

34 inch long, 1/2 inch wide I need 18

I'm hoping you can help me with this as I don't currently have access to the sash to obtain a weight on it

Looking for the right size and model balancers I need for this model. 33-5 BLS CMC 43

Would you guys have this part available?

I need the part to order for 5 sets of Balance Springs. The Metal Channel measures 34" as shown in the picture. Both Ends have wings on them.