Viewing all customer Discussions for:

26-016 3/16" x 1-1/4" Spring

This is from an MW wooden window circa 2000. The 2 inch long white plastic piece at the end of the spring is what I need to replace since it is broken on the other side. Also, the small metal rod that fits into the hole broke off of the sash. I will need to replace that as well.

I have been asked to repair the spiral balances and tilt locks on several aluminum double hung windows in a Chicago high rise. Based on the information stamped into the glass panels, I believe they are Traco windows Is this the part(in blue) that would be needed? Do you stock them and how does one ... (cont.)

The picture shows a broken piece from the bottom of my window. About 5 millimitters broke off. Please help

Only tag I can find series 875/876/877/878 I need the balances for both sides the length from bottom pin to top is 25"and would you have the pins for the bottom. Thank you

I need 50 of these little boogers, the installed pic has a broke tip, and there is the problem! CRL said they discontinued this part, please help!!

I have Better Bilt tilt windows installed in a 2002 home. Some windows have become difficult to open and close. I have not attempted to adjust the tension on the balances. Not sure whether or not to do any kind of maintenance on the hardware or just replace them. Is there any trouble shooting method ... (cont.)

do you have this sash pivot pin available. Total length including springs is 3 1/2"

This is for a glass window in a storm door

Please let me know if you have this key and what the cost is per pc. Thank you

These seem to be spring loaded at the bottom of the window the pins are gone that would go in the balance

1980's Better-Bilt double hung tilting window. Need pivot bars. The tips of mine are broken off. What remains is about 1 3/8" long. I also took a picture of the pivot so you can see what the pivot bar goes into.

These pivot bars slide into into the bottom (tilting) window and are spring loaded in a track. I found your corner tilt latches, part # 26-351, fit perfectly! But cannot seem to find a pivot bar. Your part # 26-375 for a Better-Built pivot bar did not seem the same. Mine have a square bar insert on ... (cont.)

Looking for replacement parts for internal tilt latches.

I'm having a hard time finding this replacement part for my single hung windows. Can you please assist?

Hello, I have a historic condo with old windows and one of the tilt latch has broken and need a replacement like these in the picture ! They're aluminum frame windows ! Thank you in advance ! Jay

Trying to find triple track storm window top corner tilt key to replace KAREY broken ones. Can you suggest replcements? Will need several left/right sets.Was unable to select and copy photos from my iPad using the "ADD PHOTO". Will send a separate regular email to your help@swisco.com with photos an ... (cont.)

I need a few of those do you have them?

i need one set and two springs

This metal part at the base of my window should go into what I believe is called the pivot shoe, but the end of the part is broken off on one side so it can't make that connection and of course the window won't stay open as a result.

Please let me know if you can get the attached tilt latches? Thanks.